584001
50
Zoom out
Zoom in
Vorherige Seite
1/124
Nächste Seite
Page 4-14 400 SERIES INSTALLATION MANUAL
Page Rev L P/N 190-00140-02
4.7 COM/VOR/ILS AUDIO (GNC 420 AND GNS 430 ONLY)
4.7.1 COM/VOR/ILS Audio Function and Emergency Mode
Activation of COM MIC KEY enables COM MIC AUDIO and causes the transceiver to transmit.
500 COM AUDIO and 500 VOR/ILS AUDIO are 100 mW audio outputs that are intended to drive a
headset or an audio panel.
Momentarily depressing the COM REMOTE TRANSFER button toggles the active and standby COM
frequencies. Momentarily depressing the VLOC REMOTE TRANSFER button toggles the active and
standby VLOC frequencies.
The COM REMOTE TRANSFER input may be used for EMERGENCY operation of the COM
transmitter. If the remote transfer switch is depressed for two seconds, the active COM frequency changes
to 121.50 MHz. Once the emergency frequency is activated through COM REMOTE TRANSFER, GNS
430 and GNC 420 COM transceivers with Mod 2 incorporated ignores inputs from the front panel controls
for COM selections only. The pilot may exit this independent mode—restoring COM selection control to
the front panel knobs and buttons—by momentarily depressing the COM REMOTE TRANSFER switch.
When TRANSMIT INTERLOCK is active, the GNC 420 or GNS 430 COM receiver sensitivity is
decreased. This input is intended to reduce interference from other transmitters in the aircraft. The
TRANSMIT INTERLOCK input should be connected to the PTT input of other transmitters in the aircraft.
If connected to multiple PTT inputs, these connections must include diode isolation or multiple radios
transmit simultaneously.
4.7.2 COM/VOR/ILS Audio Electrical Characteristics
4.7.2.1 COM MIC KEY
Pin Name Connector Pin I/O
COM MIC KEY P4002 4 In
This input is considered active if either the voltage to ground is < 1.9 V or the resistance to ground
is< 375 . This input is considered inactive if the voltage to ground is 11-33 V
DC
.
4.7.2.2 COM MIC AUDIO, INTERCOM MIC AUDIO
Pin Name Connector Pin I/O
COM MIC AUDIO HI P4002 6 In
COM MIC AUDIO LO P4002 18 In
INTERCOM MIC HI P4002 5 In
INTERCOM MIC LO P4002 17 In
COM MIC AUDIO and INTERCOM MIC each have a 520 AC input impedance and supply the
microphone with a 9 V bias through 620 .
COM MIC AUDIO is set in the factory for 275 mV
RMS
to modulate the transmitter at 80% nominally. The
microphone gain adjustment is accessible through the top cover.
When a 125 mV
RMS
signal at 1000 Hz is applied to the INTERCOM MIC input, the level on the COM
AUDIO output is not less than 7.07 V
RMS
.
50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin GNS 430 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info