Bedienungsanleitung Garmin GPS 120XL (Seite 64 von 72) (Englisch)

39882

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Messages &

Time Offsets

APPENDIX C

Active WPT Can’t be Deleted—You have attempted to change the “active to” or “active

from” waypoint. Clear the active route or GOTO before making your changes.

Accuracy has been Degraded—The accuracy of the GPS 120XL has been degraded

beyond 500 meters due to poor satellite geometry or data quality. You should check other

navigational sources to verify the position indicated.

Already Exists—The name you are entering already exists in the GPS 120XL’s memory.

Approaching—You are one minute away from reaching a destination waypoint.

Battery Power is Low—The batteries are low and should be replaced.

No DGPS Position—Not enough data is available to compute a DGPS position.

No RTCM Input—

Beacon receiver is improperly connected or baud rates do not match.

Poor GPS Coverage—The GPS 120XL cannot acquire the necessary number of satellites to

compute a position. Try another location with a clearer view of the sky.

Power Down and Re-init—The GPS 120XL is not able to calculate a position due to

abnormal satellite conditions. Turn the unit off and verify the last position shown by other

means. Try the unit again later, possibly in a different location.

Read Only Mem has Failed—The permanent memory has failed and the unit is not oper-

able. Take your unit to an authorized GARMIN dealer for repairs.

Received an Invalid WPT—A waypoint was received during upload transfer that has an

invalid identifier.

Receiver has Failed—A failure in receiver hardware has been detected. If this message

persists, do not use the unit and take it to an authorized dealer for repair.

Route is Full—You have attempted to add more than 30 waypoints to a route.

Route is not Empty—You have attempted to copy into a route already in use.

Route Waypoint Can’t be Deleted—The waypoint you are trying to delete is part of a

route. Delete the waypoint from the route before removing it from memory.

Route Waypoint was Deleted—A route waypoint entered does not exist in the database

and has been deleted from the route.

RTCM Input has Failed—DGPS data being received has been lost. You are no longer

receiving the beacon signal.

Searching the Sky—The GPS 120XL is in searching the sky for almanac data or the unit is

in AutoLocate

mode.

The GPS 120XL uses a flashing on-screen message to

alert you to important information. Whenever the message

indicator appears, press the PAGE key to view the message

page. There are two types of messages: temporary alerts

and condition alerts. Temporary alerts are cleared from the

message page after viewing, while condition alerts remain

on the message page until the condition has been resolved.

Pay careful attention to all messages for your own safety.

120XL Man RevB 7/10/98 10:55 AM Page 60

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GPS 120XL Seite 64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info