583794
80
Zoom out
Zoom in
Vorherige Seite
1/134
Nächste Seite
70
Reference
Main Menu: GPS Tab
The status fi eld will show one of the following conditions:
Looking For Satellites – the receiver is looking for any satellites.
AutoLocate – the receiver is looking for any satellite whose almanac has been collected. This
process can take up to fi ve minutes.
Acquiring Satellites – the receiver is looking for and collecting data from satellites visible at its last
known or initialized position, but has not collected enough data to calculate a fi x.
2D – at least three satellites with good geometry have been acquired and a 2 dimensional position
x (latitude and longitude) is being calculated. ‘2D Differential’ appears when you are receiving
DGPS corrections in 2D mode and a ‘D’ will show on the strength bar of satellites being corrected.
3D – at least four satellites with good geometry have been acquired and your position is now being
calculated in latitude, longitude and elevation. ‘3D Differential’ appears when you are receiving
DGPS corrections in 3D mode and a ‘D’ will show on the strength bar of satellites being corrected.
Poor GPS Coverage – the receiver is no longer tracking enough satellites for a 2D or 3D fi x.
Receiver Not Usable – the receiver is unusable, possibly due to interference or abnormal satellite
conditions. Turn the unit off and back on to reset.
Simulating – the receiver is in simulator mode.
The Differential Receiver status will show one of the following:
Off – No optional beacon receiver attached or enabled in the Comm menu or WAAS Off
Searching For WAAS – WAAS is enabled and receiver is searching for WAAS signal
Using WAAS – WAAS capability enabled and unit receiving WAAS corrections
No Beacon Signal – DGPS receiver attached, but not transmitting RTCM data to GPS
Tuning Beacon – Receiver is tuning manual DGPS frequency
Receiving Beacon – Unit is receiving DGPS corrections
Scanning Beacon – DGPS receiver is scanning for available frequency
Using DGPS – Indicates a Differential signal is being received (only displays when the Serial Data
Format is set to “Other DGPS” on the Comm Tab of the Main Menu)
When the GPSMAP 188/188C/238 Sounder is
using a differential correction signal (either WAAS
or DGPS), a “D” is displayed at the bottom of the
signal strength indicator bars for the satellites that
are corrected.
188188C238 Manual Part 2.indd 70 6/30/2003, 3:32:21 PM
80

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin GpSMAP 188 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info