Bedienungsanleitung Garmin GPSMAP 4010 (Seite 49 von 116) (Englisch)

501933

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

GPSMAP

4000/5000 Series Owner’s Manual 45

Almanac, Environmental, and On-boat Data

Conguring a Graph

You can set the scale and duration of the Atmospheric Pressure and Depth graphs. The duration represents the

time interval that appears on the graph, and the scale represents the range of the measured data that appears on

the graph, including specic maximum and minimum values.

1. From the Home screen, select  > .

2. Select  or .

3. Select .

4. Complete an action:

• Select , and select  or  to set the duration.

• Select . Select , , or. When you select , the chartplotter sets the optimal

minimum and maximum values for the range, based on environmental conditions. When the

chartplotter receives new data about environmental conditions, it adjusts the scale automatically.

• Select  to allow the chartplotter to set the optimal minimum and maximum values for the

range, based on environmental conditions.  is only displayed when  is already selected

for .

• For Atmospheric Pressure only, select , and select the reference time used to calculate the

barometer trend displayed in the top left corner of the graph.

Wind Speed Data

Selecting Apparent, True, or Ground Wind for the Wind Graph

The chartplotter must be connected to the peripheral devices listed below to capture the data shown on the

wind speed graph.

Wind Speed Description Required Sensors

Apparent Wind Shows wind speed data based on the ow of

air experienced while on a boat in motion�

A wind sensor�

True Wind Shows wind speed data based on the ow of

air experienced while on a stationary boat�

For the most-accurate data, the Wind Speed

Source setting should be set to Auto

(page 52)�

A wind sensor and a water speed sensor; or a

wind sensor and a GPS antenna�

Ground Wind Shows wind speed data based on the ow of

air experienced while on shore�

A wind sensor, a water speed sensor, a

heading sensor, and a GPS antenna; or a

wind sensor and a GPS antenna; or a wind

sensor, a water-speed sensor, and a heading

sensor�

1. From the Home screen, select  >  > .

2. Select the type of wind speed data included on the graph (, , or 

).

Conguring the Wind Speed Sources

You can specify whether the vessel speed data displayed on the compass is based on water speed or GPS

speed. Water speed is the speed reading from a water-speed sensor, and GPS speed is calculated from your

GPS position.

1. From the Home screen, select  > >  > .

2. Select .

3. Complete an action:

• Select  to indicate that the calculated wind speed is based on data from a Water Speed

sensor.

• Select  to indicate that the calculated wind speed is based on data from a GPS antenna.

• Select  to allow the chartplotter to select a speed data source automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GPSMAP 4010 Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin GPSMAP 4010

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info