Bedienungsanleitung Garmin GPSMAP 526s (Seite 72 von 78) (Englisch)

585694

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

Appendix

66 GPSMAP 400/500 Series Owner’s Manual

either been disconnected or the unit has lost communication with the sonar

device for some other reason.

—you entered a saved track name that

already exists in memory. Modify the track name or delete the existing track.

—the track log is full and track recording has been turned

off. To record more track points, you need to clear the track log and turn track

recording on. This only appears when the track recording setting is set to “Stop

When Full.”

—the track log memory is full.

No additional track log data can be stored without deleting old data to create

memory space.

—a complete uploaded track does not t into memory. The

oldest track log points were deleted to make space for the most recent data.

—there is not a transducer

attached, there is a bad cable or transducer, or the transducer cable was

disconnected. If the transducer cable is removed while the unit is on, reconnect

and cycle power.

—the unit has nished uploading or downloading

information to the connected device.

—attempted to transfer user data

without an SD card containing user data being present in the SD card slot.



—the auto-guidance route was calculated but the starting

and ending positions were moved because of safe depth settings.

—the speed sensor is not detected.

Check the connections.

—sonar has reported a temperature above, below,

inside, or outside the specied values.

—you entered a waypoint name that already exists

in memory. Modify the waypoint name or delete the existing waypoint.

—you have saved the maximum number of

waypoints. Delete unwanted waypoints to make space for new entries.



You can capture a screenshot of any screen displayed on your unit as a bitmap

(.BMP) le and then transfer it to your computer.



1. Insert an SD card into the SD card slot on the front of the unit.

2. Select  >  > .

3. Select  to turn screenshot captures .

4. When you are on a screen you want to capture, press and hold the 

button for at least six seconds.

5. Select  when the Screenshot Taken window is displayed.



1. Remove the SD card from the chartplotter and insert it into an SD card

reader that is attached to a computer.

2. From Windows Explorer, open the Garmin\scrn folder on the SD card.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GPSMAP 526s Seite 72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin GPSMAP 526s

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info