Bedienungsanleitung Garmin GPSMAP 556s (Seite 58 von 78) (Englisch)

585695

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

Conguring the Chartplotter

52 GPSMAP 400/500 Series Owner’s Manual



1. If the transducer is installed at the water line

➊

, measure the distance from

the transducer location to the keel of the boat. Enter this value in step 3 as a

positive number.

If the transducer is installed at the bottom of the keel

➋

, measure the

distance from the transducer to the water line. Enter this value in step 3 as a

negative number.

➊

➋

2. From the Home screen, select  >  > .

3. Enter the distance measured in step 1. Ensure that you enter a positive or a

negative number based on the location of the transducer.

4. Select  to accept the number.

—set the temperature offset for the temperature sensor of your

transducer.



You must have a NMEA 0183 water-temperature sensor, a Garmin Intelliducer,

or a temperature-capable transducer to measure water temperature.

The temperature offset compensates for the temperature reading from a

temperature sensor.

1. Measure the water temperature using the temperature sensor or

temperature-capable transducer that is connected to the chartplotter.

2. Measure the water temperature using a different temperature sensor or a

thermometer that is known to be accurate.

3. Subtract the water temperature measured in step 1 from the water

temperature measured in step 2.

This is the temperature offset. Enter this value in step 5 as a positive

number if the sensor connected to the chartplotter measures the water

temperature as being colder than it actually is. Enter this value in step 5 as

a negative number if the sensor connected to the chartplotter measures the

water temperature as being warmer than it actually is.

4. From the Home screen, select  >  > .

5. Enter the temperature offset calculated in step 3.

6. Select .

—use this menu to calibrate a speed-sensing device.

Follow the on-screen directions for calibration. If you do not have a speed-

sensing device, this menu does not appear.

 If the boat is not moving fast enough or the speed sensor is not

registering a speed, a “Speed Too Low”message appears. Select , and

safely increase the speed of the boat. If you get the message again, stop the

boat and make sure the speed-sensor wheel is not stuck. If the wheel turns

freely, check the cable connections. If you continue to get the message, contact

Garmin Product Support.

—enter the combined fuel capacity of all the engines on your

boat.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GPSMAP 556s Seite 58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin GPSMAP 556s

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info