Bedienungsanleitung Garmin GPSMAP 740 (Seite 17 von 100) (Englisch)

501972

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

GPSMAP 700 Series Owner’s Manual 13

Charts and 3D Chart Views

➍

The location of this symbol indicates the closest point of approach to a dangerous target,

and the numbers near the symbol indicate the time to the closest point of approach to

that target.

➎

Dangerous target in range. The target ashes while an alarm sounds and a message

banner appears. After the alarm is acknowledged, a solid red triangle with a red line

attached to it indicates the location and the heading of the target. If the safe-zone

collision alarm is set to Off, the target ashes, but the audible alarm does not sound and

the alarm banner does not appear (page 15). If the AIS transmission from the vessel is

lost, a message banner appears.

➏

Target is lost. A green X indicates that the AIS transmission from the vessel is lost, and

the chartplotter displays a message banner asking whether the vessel should continue to

be tracked. If you discontinue vessel tracking, the lost target symbol disappears from the

chart or the 3D chart view.

Target is selected.

AIS-SART transmission. You can select this symbol to see more information about the

SART transmission and begin navigation.

AIS-SART transmission lost.

AIS-SART transmission test. This symbol appears when a vessel initiates a test of their

SART device, and does not represent a true emergency. You can disable these test

symbols and alerts (page 14)

AIS-SART transmission test lost.

Heading and Projected Course of Activated AIS Targets

When heading and course over ground information are provided by an activated AIS target, the heading of the

target appears on a chart as a solid line attached to the AIS target symbol. A heading line does not appear on a

3D chart view.

The projected course of an activated AIS target appears as a dashed line on a chart or a 3D chart view. The

length of the projected course line is based on the value of the projected heading setting (page 14). If an

activated AIS target is not transmitting speed information, or if the vessel is not moving, a projected course

line does not appear. Changes in the speed, the course over ground, or the rate-of-turn information transmitted

by the vessel can impact the calculation of the projected course line.

When course over ground, heading, and rate of turn information are provided by an activated AIS target

➊

, the

projected course

➋

of the target is calculated based on the course over ground and the rate of turn information.

The direction in which the target is turning, which is also based on the rate of turn information, is indicated by

the direction of the barb

➌

at the end of the heading line

➍

. The length of the barb does not change.

➍

➌

➋

➊

Target with Projected Course, Heading, and Direction of Turn

When course over ground and heading

➎

information are provided by an activated AIS target

➏

but rate of

turn information is not provided, the projected course

➐

of the target is calculated based on the course over

ground information.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GPSMAP 740 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin GPSMAP 740

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info