REMOTE DME
DME REQUEST
CLOCK BUS
DATA BUS
KING SERIAL DME (REMOTE-MOUNTED)
F
6
D
BENDIX/KING
KN63
P631
DME INDICATOR
RNAV REQUEST
CLOCK BUS
DATA BUS
15
11
12
BENDIX/KING
KDI 572 KDI 574
P5721 P5741
NAV 1 COMMON48
DME REQUEST
NAV 2 COMMON
17
49
15
11
12
48
17
49
P1004
18
19
20
SERIAL DME-RNAV/CH REQ
SERIAL DME-DATA
SERIAL DME-CLOCK
GTN 650/750 #1
41NAV DME COMMON
s
s
s
P1004
18
19
20
SERIAL DME-RNAV/CH REQ
SERIAL DME-DATA
SERIAL DME-CLOCK
GTN 650/750 #2
41NAV DME COMMON
s
s
s
KDM 706
P7061
8
9
24
10 BIT/50 BIT SELECT33 33N/C
s
s
s
s
s
s
s
s
s
s
s
s
s
s
s
7
7
7
7
7
NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS: SHIELD BLOCK GROUND AIRFRAME GROUND
3. AT GTN 650/750, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL -- THE SHIELD TERMINATION LEADS
MUST BE LESS THAN 3.0". CONNECT OTHER END OF THE SHIELD PER THE REMOTE EQUIPMENT INSTALLATION
REQUIREMENTS. IF NO SHIELD TERMINATION REQUIREMENT EXISTS FOR THE REMOTE EQUIPMENT, TERMINATE
SHIELDS AS SHORT AS POSSIBLE, NOT TO EXCEED 3.0". SEE SECTION 2.4.11.4.
4. REFER TO MANUFACTURER’S DOCUMENTATION FOR COMPLETE PINOUT AND INTERCONNECT INFORMATION. PINOUTS
OF OTHER UNITS SHOWN FOR REFERENCE ONLY.
5. THE GTN 650/750 MUST BE CONFIGURED AT INSTALLATION TO OUTPUT KING SERIAL DME TUNING DATA UNDER THE
DME CHANNEL MODE. REFER TO SECTION 5.5.1.11 FOR CONFIGURATION SETTINGS.
6. FOR SINGLE GTN INSTALLATIONS, WIRE AS SHOWN FOR GTN #1.
7. THE SPLICE MUST BE PERFORMED AT THE GTN CONNECTOR END OF THE WIRE. SPLICE AS SHOWN:
s
P100X
s
s
GTN
