Bedienungsanleitung Garmin gWind (Seite 3 von 46) (Alle Sprachen)

691470

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

Item Description

gWind device

Included Nexus

mast cable with a field-installable connector

GND 10

NMEA 2000 network

Nexus Connection Considerations

If you change from a Nexus wind sensor to the gWind sensor,

you must move the mast cable from the wind port to the network

port on the Nexus server on pins 5, 6, 7, and 8. The network

server is NX2, and the classic server is BUS. See the Nexus

device manual for more information.

Installing the Nexus Field-Installable Connector

You must use the included field-installable connector to create

the appropriate cable length for your installation.

Connect the finished end of the included bulk cable to the

wind transducer on the mast.

Route the bare end of the cable to the location of the

GND 10.

Leaving an appropriate amount of slack, cut the bare end of

the wire, remove the casing, and strip the individual wires.

Disassemble the field-installable connector and place the

pressing screw

, pinch ring

, seal

, and sleeve

on the

cable

Using the screws on the back of the connector

, connect

each wire to the appropriate terminal.

Terminal Number Wire Color

Green

Yellow

Bare wire

White

Screw the sleeve onto the connector.

Slide the seal into the sleeve and slide the pinch ring over the

seal.

Screw the pressing screw into the sleeve to complete the

assembly of the field-installable connector.

Connect the field-installable connector to either NEXUS port

on the GND 10.

Configuring the Wind Transducer

Before you can configure the wind transducer, it must be

connected through a GND 10 to a NMEA 2000 network with a

Garmin marine instrument, such as a GMI

™

20. Refer to the

marine instrument owner's manual for more information on

configuring NMEA 2000 devices.

On the marine instrument, go to the NMEA 2000 settings.

Select the name of the device (GND 10) to configure.

Adjusting the Orientation

You should adjust this setting if the sensor does not face the

exact front of the boat.

On the marine instrument, from the NMEA 2000 settings,

select the device name (GND 10).

Select Wind Angle Offset.

Based on the direction in which the sensor is facing in

relation to the exact center of the front of the boat, select the

angle in degrees to adjust for the difference in orientation.

The angle is configured clockwise around the mast of the

boat, from the exact center of the front of the boat. For

example, 90 degrees is starboard, and 270 degrees is port.

Select Done.

Adjusting the Wind Angle Filter

You should adjust this setting to change the responsiveness of

the display to changes in the wind direction.

On the marine instrument, from the NMEA 2000 settings,

select the device name (GND 10).

Select Wind Angle Filter.

Select an option:

• Select Off to turn off the filter and make the display the

most responsive to changes in the wind angle.

• Select On and adjust the value. Select a higher number to

increase the responsiveness of the display to changes in

the wind angle, or select a lower number to decrease the

responsiveness.

• Select Auto to automatically adjust the filter settings

based on wind conditions.

Select Done.

Adjusting the Wind Speed Filter

You should adjust this setting to change the responsiveness of

the display to changes in the wind speed.

On the marine instrument, from the NMEA 2000 settings,

select the device name (GND 10).

Select Wind Speed Filter.

Select an option:

• Select Off to turn off the filter and make the display the

most responsive to changes in the wind speed.

• Select On and adjust the value. Select a higher number to

increase the responsiveness of the display to changes in

Installation Instructions 3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin gWind Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info