691272
8
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
Device Information
Vector Device Care
NOTICE
Keep the components clean and free of debris.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that can
damage plastic components and finishes.
Do not submerge or pressure wash the components.
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
Replace components with Garmin parts only. See your Garmin
dealer or the Garmin website.
Maintenance Tips
NOTICE
Some bike tools may scratch the finish of Vector components.
Use wax paper or a towel between the tool and the hardware.
After any bike adjustments, rotate the crank arm to check for
clearance.
Keep Vector components clean.
When moving Vector to another bike, clean the threads and
surfaces thoroughly.
Go to www.garmin.com/manuals/vector3 for the latest
updates and information.
Vector Specifications
Battery type User-replaceable LR44 or SR44, 1.5 V, 2 per
pedal
Battery life Up to 120 hr. of riding time, with cycling
dynamics
Operating
temperature range
From -14° to 122°F (from -10° to 50°C)
SR44 batteries may perform better in cold
temperatures.
Wireless
frequencies/
protocols
ANT+ 2.4 GHz @ 3 dBm nominal
Bluetooth
®
2.4 GHz @ 3 dBm nominal
Water rating IEC 60529 IPX7*
*The device withstands incidental exposure to water of up to 1 m
for up to 30 min. For more information, go to www.garmin.com
/waterrating.
Battery Information
The Vector system monitors the battery level of both pedals and
sends status information to your Edge device. When you receive
a low battery warning, you have approximately 10–20 hours of
operation time remaining.
Replacing the Batteries
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Each pedal uses two LR44 or SR44, 1.5 V batteries.
NOTE: Garmin recommends replacing all of the batteries at the
same time. Do not mix the battery types.
1
Use a 4 mm hex key to remove the battery cover
À
.
2
Remove the batteries.
3
Wait 5 to 10 seconds.
4
Insert the new batteries into the battery cover, observing
polarity.
5
Replace the battery cover, and hand tighten it.
NOTE: Do not damage or lose the O-ring gasket.
6
Use a 4 mm hex key to gently tighten the battery cover.
NOTE: Do not over-tighten the battery cover. The cover is
sufficiently tight when the O-ring gasket is no longer visible.
The pedal LED flashes red once.
Overhauling the Vector Pedals
You can disassemble and reassemble the pedal spindles to clean and grease the components.
NOTICE
Garmin recommends overhauling one pedal at a time taking care to keep track of the small screws and seals. You must obtain a 4
mm hex key, PH 00 screwdriver, 15 mm pedal wrench, 12 mm socket wrench with an outer diameter that is less than 17 mm
(typically a
1
/
4
in. drive), and bike grease. Use care not to damage any of the Vector components.
NOTE: If you have the Vector 3S system, the right pedal has no battery carriage.
1
Use a 15 mm pedal wrench to remove the pedals.
NOTE: The left pedal spindle has a left-handed (reverse) thread attaching it to the crank arm.
2
Use a 4 mm hex key to remove the battery cover
À
.
4 Device Information
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin Vector 3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Garmin Vector 3

Garmin Vector 3 Bedienungsanleitung - Deutsch - 16 seiten

Garmin Vector 3 Bedienungsanleitung - Holländisch - 14 seiten

Garmin Vector 3 Bedienungsanleitung - Französisch - 16 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info