Bedienungsanleitung Garmin VOLVO PENTA GLASS COCKPIT GPSMAP 7600 (Seite 46 von 76) (Englisch)

691433

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Select an increment.

Setting the Power Saver

You can adjust the level of rudder activity.

From the autopilot screen, select Menu > Autopilot Setup >

Power Mode Setup > Power Saver.

Select a percentage.

Selecting a higher percentage reduces rudder activity and

heading performance. The higher the percentage, the more

the course deviates before the autopilot corrects it.

TIP: In choppy conditions at low speeds, increasing the

Power Saver percentage reduces rudder activity.

Enabling Shadow Drive

™

From the autopilot screen, select Menu > Autopilot Setup >

Shadow Drive > Enabled.

Selecting the Preferred Heading Source

NOTICE

For best results, use the autopilot CCU internal compass for the

heading source. Using a third-party GPS compass can cause

the data to be delivered erratically and may result in excessive

delays. The autopilot needs timely information, and therefore

cannot often use third-party GPS compass data for GPS

location or speed. If a third-party GPS compass is used, the

autopilot will likely report loss of navigation data and speed

source periodically.

If you have more than one heading source on the network, you

can select a your preferred source. The source could be a

compatible GPS compass or a magnetic heading sensor.

From the autopilot screen, select Menu > Autopilot Setup >

Preferred Sources

Select a source.

If the selected heading source is unavailable, the autopilot

screen does not display any data.

Autopilot Overlay Bar

NOTE: Not all options are available on all autopilot models.

Autopilot mode

Enables the heading hold

Steers left

Actual heading

Rudder position indicator (available only when a rudder sensor is

connected)

Intended heading (heading the autopilot is steering toward)

Steers right

Engages the steering pattern

Opens the full autopilot screen and menu

Engaging the Autopilot

When you engage the autopilot, the autopilot takes control of the

helm and steers the boat to maintain your heading.

From any screen, select Engage.

Your intended heading shows in the center of the Autopilot

screen.

Adjusting the Heading with the Helm

NOTE: You must enable the Shadow Drive feature before you

can adjust the heading using the helm (Enabling Shadow

Drive

™

, page 38).

With the autopilot engaged, manually steer the boat.

The autopilot activates Shadow Drive mode.

When you release the helm and manually maintain a specific

heading for a few seconds, the autopilot resumes a heading

hold at the new heading.

Adjusting the Heading with the Chartplotter in Step

Steering Mode

Before you can steer your boat using the keys at the bottom of

the autopilot screen, you must engage the autopilot (Engaging

the Autopilot, page 38).

• Select <1° or 1°> to initiate a single 1° turn.

• Select <<10° or 10°>> to initiate a single 10° turn.

• Hold <1° or 1°> to initiate a rate-controlled turn.

The boat continues to turn until you let go of the key.

• Hold <<10° or 10°>> to initiate a sequence of 10° turns.

Steering Patterns

WARNING

You are responsible for the safe operation of your boat. Do not

begin a pattern until you are certain that the water is clear of

obstacles.

The autopilot can steer the boat in preset patterns for fishing,

and it can also perform other specialty maneuvers such as U-

turns and Williamson turns.

Following the U-Turn Pattern

You can use the u-turn pattern to turn the boat around 180

degrees and maintain the new heading.

From the autopilot screen, select Menu > Pattern Steering >

U-Turn.

Select Engage Port or Engage Starboard.

Setting Up and Following the Circles Pattern

You can use the circles pattern to steer the boat in a continuous

circle, in a specified direction, and at a specified time interval.

From the autopilot screen, select Menu > Pattern Steering >

Circles.

If necessary, select Time, and select a time for the autopilot

to steer one complete circle.

Select Engage Port or Engage Starboard.

Setting Up and Following the Zigzag Pattern

You can use the zigzag pattern to steer the boat from port to

starboard and back, over a specified time and angle, across

your present heading.

From the autopilot screen, select Menu > Pattern Steering >

Zigzag.

If necessary, select Amplitude, and select a degree.

If necessary, select Period, and select a length of time.

Select Engage Zigzag.

Following the Williamson Turn Pattern

You can use the Williamson turn pattern to steer the boat

around with the intent of running alongside the location where

the Williamson turn pattern was initiated. The Williamson turn

pattern can be used in man overboard situations.

From the autopilot screen, select Menu > Pattern Steering >

Williamson Turn.

Select Engage Port or Engage Starboard.

38 Autopilot

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin VOLVO PENTA GLASS COCKPIT GPSMAP 7600 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin VOLVO PENTA GLASS COCKPIT GPSMAP 7600

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info