Bedienungsanleitung Garmin Zumo 310 (Seite 15 von 24) (Englisch)

501819

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Select Go!.

Saving Your Recent Track as a Trip

You can save your recent track as a trip, which you can

navigate later using the trip planner (page 10).

Select TracBack.

Your recent track appears on the map.

Select Save as Trip.

Enter a name, and select Done.

Tire Pressure

WARNING

Use of the Tire Pressure Monitor System is not a substitute for

proper tire maintenance, and it is the driver's responsibility to

maintain correct tire pressure, even if under-inflation has not

reached the level to trigger the low tire pressure alert. Failure to

maintain proper tire pressure can result in loss of control of the

vehicle, which may lead to serious personal injury or death.

The Garmin Tire Pressure Monitor System is available as a

separate accessory. The tire pressure feature is not compatible

with all zūmo models. Go to www.garmin.com/zumo for

accessory and compatibility information.

Setting Up the Tire Pressure Sensors

Before you can set up the tire pressure sensors, you must have

the battery and the numerical stickers included with

each sensor. You also must have a compatible zūmo device.

The sensors communicate wirelessly with your compatible

zūmo device. You can monitor tire pressure and receive low-

pressure alerts on your zūmo device.

Remove the cap

from the sensor

by rotating the cap

counter-clockwise.

If you have already installed the battery in the sensor,

remove the battery.

On your zūmo device, select Apps > Tire Pressure.

Select a vehicle profile that matches the tire configuration of

your vehicle.

Bring the sensor close to the zūmo device.

On your zūmo device, select the number next to the tire to

which the sensor will be paired.

Within 30 seconds, on the sensor, insert the battery

into

the battery holder

with the positive side facing up.

The

zūmo device searches for the sensor and displays a

confirmation message when the sensor pairs successfully.

TIP: If the sensor does not pair successfully, you should

remove the sensor battery, and repeat steps 6 and 7.

Enter the recommended pressure for the tire.

Enter the minimum pressure for the tire.

The zūmo device triggers a low-pressure alert when the

sensor reports a tire pressure reading lower than this value.

Replace and fully tighten the cap on the sensor.

On the sensor, affix the numerical sticker that corresponds to

the tire number you selected in step 6.

Repeat this procedure for each remaining sensor.

Installing the Sensors on Your Tires

WARNING

The Tire Pressure Monitor System is for use with metal tire

valve stems only. Installation of the Tire Pressure Sensors on

non-metal tire valve stems may cause tire and/or tire valve stem

damage which could result in serious personal injury or death.

NOTICE

To prevent possible damage to the sensors or vehicle, ensure

each installed sensor does not interfere with the vehicle brakes,

suspension components, or other installed equipment. If an

installed sensor interferes with any installed equipment on the

vehicle, do not operate the vehicle with the sensor installed.

To prevent possible tire vibration or uneven tire wear on some

vehicles, it may be necessary to balance the vehicle tires after

installing the sensor.

Before you install the sensors on your tires, you should set up

the sensors with your zūmo device.

Remove the existing valve stem caps from your vehicle tires.

On your zūmo device, select Apps > Tire Pressure to view

the vehicle profile diagram.

Install the sensors onto the tire valve stems by tightening

them clockwise.

NOTE: You must install each sensor onto the correct tire

based on the vehicle profile diagram and the numerical

stickers affixed to the sensors during the setup process.

Rotate the wheels by hand to verify the sensors have

adequate clearance and do not interfere with vehicle

equipment.

Tire Pressure Alerts

The device alerts you using pop-up messages, icons on the

map, and symbols in the tire pressure app.

When an alert exists for a sensor, the number next to the

corresponding tire appears red in the tire pressure app. The

symbols below the number appear red to indicate the active

alerts for that sensor.

Using the Apps 11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Zumo 310 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Zumo 310

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info