Bedienungsanleitung Gastroback 41007 (Seite 50 von 54) (Deutsch, Englisch)

714643

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

Problem Possible Reason The Solution

Liquid is running down on

the power base or accumula-

ting below the power base.

The lid is not closed properly. Close the lid. The rim of the lid must lie on the rim of the jug

without any gap. Clean the appliance and leave it dry for 1 day.

There is too much food or liquid in

the jug.

Take some of the food out of the jug. Try working in smaller

portions. Clean the appliance and leave it dry for 1 day.

The jug is leaking. Immediately switch off and unplug the appliance, then take the

jug away from the power base. Clean the power base, and leave

it dry naturally for at least 1 day. Contact an authorized service

centre for examination and repair.

CARE AND CLEANING

WARNING: Always ensure that the appliance is out of reach of young child-

ren. The cutting blades in the jug are very sharp. Handle with care to avoid

injuries.

Always switch off the appliance (press ON | OFF button), then unplug the appliance, before

moving or cleaning the appliance. Do not attempt to move the appliance during operation.

Ensure to protect the power base and power cord against splashing water and moisture. Do

not immerse the power base, or power cord in water or any other liquid, to avoid hazards

due to electric shock and damage. Do not spill or drip any liquids on or in the power base

and power cord to avoid risk of fire and electric shock. This holds especially for the ventilati-

on slits at the rear of the power base and the drive shaft coupling in the centre of the power

base. Do not clean the power base or power cord in an automatic dishwasher!

Do not scratch or cut on the surfaces of the appliance or the seal of the lid or use any violence.

Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any corrosive

chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to avoid damage to the

surfaces. Do not immerse the power base or power cord in water or any other liquid. Do not

spill or drip any liquids on the power base, or on the power cord to avoid risk of fire and

electric shock.

Always keep the appliance clean. When food splatters or spilled liquids adhere to the outer

surfaces, wipe with a damp cloth. Mild detergent may be used. Thereafter, thoroughly dry

all parts.

Cleaning the Appliance

Jug, Lid, and Measuring Cup

In order to keep your Design Mixer Advanced Professional clean, you should prevent food

from drying on the surfaces. This holds especially for the cutting blades, jug and lid, because

these parts will get directly in contact with food. Thus, follow the steps below as soon as

possible after use.

Tip: Please note that milling hard ingredients (e.g. spices, nuts, sugar, coffee, and grains) will

cause scratching and clouding to the inside surfaces of the jug. This is a cosmetic problem,

and does not affect the performance of the appliance.

1. Rinse most of the coarse reminders off the jug, lid, and measuring cup with tap water.

IMPORTANT: Ensure that the drive shaft of the jug is always clean and dry before placing

the jug onto the power base, to avoid moisture and residues of food getting into the drive

shaft coupling.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gastroback 41007 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info