Bedienungsanleitung Gastroback 42434 (Seite 60 von 68) (Deutsch, Englisch)

714678

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Problem Reason The Solution

You cannot start the desired

program.

The kettle is not placed on

the power base correctly.

Fill the kettle with at least 0.5 litres of water and place the

kettle on the power base. If required, turn the kettle on the

power base. Then try again.

The set temperature is

lower than or equal to the

current water temperature

within the kettle.

The set temperature must be higher than the current tempera-

ture within the kettle to start a program. Wait until the kettle

cooled down sufficiently, select a somewhat higher tempera-

ture, or carefully pour some cold water into the centre of

the kettle (see: ‘Adding Water during Operation’).

Water accumulates under

the power base or runs

down on the exterior of the

kettle.

There is too much water in

the kettle.

Immediately unplug the appliance. Then wipe dry the appli-

ance completely. Leave the appliance dry naturally for at

least 1 day. Always observe the maximum filling level when

filling (see: ‘Technical Specifications’).

You spilled some water

during filling or moving the

kettle.

Immediately unplug the appliance. Then wipe dry the appliance

completely. Leave the appliance dry naturally for at least 1 day.

Ensure not to spill water on the exterior of the kettle during fil-

ling. Always ensure to hold the kettle level when it is filled.

The kettle is leaking. Immediately unplug the appliance and wipe dry the appli-

ance completely. Then check the kettle for leakage. Do not

use the appliance, if the kettle is leaking.

The water has an

unpleasant taste.

This may happen on new

appliances or appliances

that are used only rarely.

Prepare the appliance for usage as described in chapter

‘Before First Use’. If the problem persists, fill the kettle with

1200 ml of water and add two teaspoons of soda. Bring the

water to the boil using the program “100°C / Hot Water”.

Then discard the water and clean the kettle thoroughly.

You left the water in the

kettle for too long.

Always discard residues of water or tea completely after usage

and at least rinse the kettle with clear tap water, before stan-

ding the kettle aside. However, after preparing tea, it is better

to clean the kettle after usage (see: ‘Care and Cleaning’).

When cooking tea within the

kettle, the interior of the kettle

may get coated with residues

of tea, causing a bitter taste,

when simply heating water.

At least, when using the appliance for cooking tea and, the-

reafter, heating clear water, thoroughly clean the kettle and

lid set (see: ‘Care and Cleaning’).

The program “100°C /

Hot Water” is used but the

water is not boiling.

For the keep warm function,

the maximum temperature is

limited to 90-95°C.

According to the pre-set course of this program, the water is

heated to the boil only shortly. Thereafter, the water tempe-

rature will drop a little. This is normal. No action required.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gastroback 42434 Seite 60

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info