Bedienungsanleitung Gazco Ashdon - Conventional Flue (Seite 16 von 32) (Englisch)

813473

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Installation Instructions

1. Safety Precautions

IMPORTANT: ALWAYS WEAR THE GLOVES

PROVIDED WHEN HANDLING AN IVORY

PAINTED APPLIANCE.

1.1 For your own and other’s safety, you must install this

appliance according to local and national codes of practice.

Failure to install the appliance correctly could lead to

prosecution. Read these instructions before installing

and using this appliance.

1.2 These instructions must be left intact with the user.

1.3 Do not attempt to burn rubbish on this appliance.

1.4 Keep all plastic bags away from young children.

1.5 Do not place any object on or near to the appliance and

allow adequate clearance above the appliance.

IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT

IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO

RELIGHT THE APPLIANCE.

IMPORTANT: REFER TO DATA BADGE AND

TECHNICAL SPECIFICATION AT THE FRONT OF

THE MANUAL TO ENSURE THE APPLIANCE IS

CORRECTLY ADJUSTED FOR THE GAS TYPE

AND CATEGORY APPLICABLE IN THE COUNTRY

OF USE.

FOR DETAILS OF CHANGING BETWEEN GAS

TYPES REFER TO SERVICING, SECTION 11,

REPLACING PARTS.

Unpacking

1.6 Remove the appliance from its packaging, and check that it

is complete and undamaged.

2. Upgrading the Appliance

2.1 The appliance is fitted with a control valve that can easily be

upgraded to battery powered remote control.

There are two versions of this control which can be obtained

through your local Gazco stockist.

There is no requirement for this upgrade to be carried out by

an approved Gas engineer. However Gazco recommend

that this task is undertaken by a suitably competent person.

2.2 This upgrade can be fitted before or after installation but if

side clearances are limited then it will be easier to upgrade

the appliance before installation. Full instructions are

included with the kit.

Standard Remote Control

(PART NUMBER 8455)

2.3 This remote control can control the gas appliance after

the pilot has been lit. It can turn the main burner on and

regulate it from low through to high and back again.

It can turn the main burner off leaving the pilot burning.

Thermostatic and Timer Remote Control

(PART NUMBER 8456)

2.4 This remote control can control the gas appliance after the

pilot has been lit.

MANUAL MODE

Can be used to turn the main burner on and manually

regulate it from low through to high and back again. It can

also be used to turn the main burner off leaving the pilot

burning.

AUTO MODE

Will automatically regulate the room to a pre-set temperature.

TIMER MODE

Will turn the appliance on and off according to a pre-set

programme and automatically regulate the room temperature

during the two on periods.

3. Installation of the Appliance

IMPORTANT: THE OUTER PANELLING AND DOOR

OF THE APPLIANCE IS MADE FROM CAST IRON .

TAKE CARE WHEN INSTALLING, REMOVING AND

STORING TO AVOID DAMAGING THE OUTER

CASING, HEARTH OR DOOR.

3.1 The ceramic logs are located behind the door.

3.2 Remove the 4 black nuts retaining the door, see Diagram 1.

Take care when removing the door as it is heavy. Place

carefully to one side.

Remove the box and place in a safe location.

REFER TO SITE REQUIREMENTS SECTION FOR ALL

FLUE OPTIONS.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gazco Ashdon - Conventional Flue Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info