Bedienungsanleitung Gazco Ceramica Manhattan 8578-P8578 (Seite 10 von 23) (Englisch)

813361

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

AR0509

AR0531

2.7 The stove is fitted with the Gazco Flue Sure System, which

acts to cut off the gas supply to the appliance in the event

of incorrect operation of the flue. If the system acts to shut

off the gas supply, this indicates there is insufficient flue

pull. If this occurs a minimum of 10 minutes should be

allowed before trying to relight. Continued operation of this

safety device means there may be a serious problem with

the flue system and a qualified gas engineer must inspect.

DO NOT USE THE STOVE UNTIL AN ENGINEER SAYS IT

IS SAFE TO DO SO.

2.8 Do not tamper with the Flue Sure System Use only genuine

Gazco replacement parts when servicing the system - refer

to Servicing Instructions, Replacing Parts.

3. INSTALLATION OF THE STOVE

3.1 Open the carton containing the engine assembly, and

carefully remove the engine. It will now be necessary to

decide upon top or rear flue exit, the stove is factory built

for rear flue exit, but it may be changed to top exit by

simply using the following method.

3.2 Remove the flue spigot from the rear of the stove and

replace with the blanking plate from the top of the stove.

Refit flue spigot to top of stove.

3.3 When installing with a top flue please note the flue pipe fits

through a hole in the top grill, the dimensions are for floor

fixing a top flue installation with clearance for side panels.

3.4 Position the engine assembly in its intended location and

mark the position of the two floor fixing holes at the base of

each side of the subframe, minimum fixing dimensions to a

rear wall are shown in Diagram 3.

IMPORTANT: ENSURE THAT THE APPLIANCE IS

CORRECTLY ADJUSTED FOR THE GAS TYPE AND

CATEGORY APPLICABLE IN THE COUNTRY OF USE.

REFER TO DATABADGE AND TECHNICAL

SPECIFICATIONS OF THIS BOOKLET.

FOR DETAILS OF CHANGING BETWEEN GAS TYPES

REFER TO SERVICING INSTRUCTIONS, REPLACING

PARTS.

1. CONTROL UPGRADE

1.1 This stove is fitted with a control valve that can be easily

upgraded to battery powered remote control. There are two

versions of this control which can be obtained through your

local Gazco stockist.

1.2 This upgrade can be fitted before or after installation but if

side clearances are limited then it will be easier to upgrade

the stove before installation. Full instructions are included

with the kit.

1.3 STANDARD REMOTE CONTROL. This remote controls the

gas appliance after the pilot has been lit. It can turn the

main burner on and regulate it from low through to high

and back again. It can turn the main burner off leaving the

pilot burning GAZCO PART NUMBER 8455.

1.4 THERMOSTATIC AND TIMER REMOTE CONTROL. This

remote controls the gas appliance after the pilot has been

lit. In ‘MANUAL MODE’ it can be used to turn the main

burner on and manually regulate it from low through to

high and back again. It can also be used to turn the main

burner leaving the pilot burning. In ‘AUTO MODE’ it will

automatically regulate the room temperature to a pre-set

temperature. In ‘TIMER MODE’ it will turn the fire on and

off according to a pre-set programme and automatically

regulate the room temperature during the two ON periods.

GAZCO PART NUMBER 8456.

2. SAFETY PRECAUTIONS

2.1 This appliance must be installed in accordance with the

rules in force and used only in a sufficiently ventilated

space. Place read these instructions before installation and

use of this appliance.

2.2 All the instructions must be left intact with the user.

2.3 In your own interest, and those of safety, this appliance

must be installed by a competent person in accordance

with local and national codes of practice. Failure to install

the appliance correctly could lead to prosecution.

2.4 This appliance is intended for use on a governed gas

installation and set to the required pressure.

2.5 Keep all plastic bags away from young children.

2.6 Do not place any object on or near to the stove. Allow

adequate clearance above the stove. See Diagram 2,

Appliance Location..

INSTALLATION INSTRUCTIONS

INSTALLATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gazco Ceramica Manhattan 8578-P8578 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info