Bedienungsanleitung Gazco Riva Nemos Coprecci (Seite 21 von 34) (Englisch)

813402

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

HEADING

d) How the appliance works with the touch pad control

(Section 2B of the User Instructions).

e) How the appliance works with the remote control

handset and the modes of operation (Section 2A of the User

Instructions).

g) What to do if the appliance fails to operate (Section 13 of

the User Instructions).

2. PAIRING THE HANDSET WITH THE

APPLIANCE

Prior to re-connection of the control box to the appliance,

if there is no communication between the remote handset

and the appliance, or if the handset is replaced, it will be

necessary to pair the (new) handset with the appliance.

2.1 Remove the 2 x screws securing the control box bracket.

AR2704

Screws

2.2 Ensure batteries are fitted and working in the handset.

2.3 Ensure all leads and cables are connected correctly.

2.4 Press the On/Off button (�) for at least 10 seconds. The

LED will flash on and off as normal during this time. When

the LED on the control lights up for at least 1 second

release the button.

2.5 Within 5 seconds of the LED going out press the () button

followed directly by the () button.

2.6 Within 20 seconds press the yellow button on the control

box (see Diagram 2). This may be easier using a pencil, ball

point pen or similar.

YELLOW FLAMES WILL APPEAR WHEN THE FIRE HAS

GAINED SUFFICIENT HEAT - TYPICALLY 10 TO 20 MINUTES.

TOUCH PAD CONTROL NOT WORKING

If the appliance is not operating with the touch pad

control:

6.15 Replace the batteries in the battery pack following Section 4.

6.16 If the appliance still fails to operate consult your installer or

Gazco dealer.

7. TURNING THE APPLIANCE OFF

REMOTE CONTROL

7.1 To turn the appliance off press the On/Off (�) button once.

TOUCH PAD CONTROL

7.2 To turn the appliance off press the On/Off button once.

IF THE FIRE IS EXTINGUISHED OR GOES OUT IN USE,

WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT

IT. THE CONTROL VALVE HAS AN INTERLOCK DEVICE

AND THEREFORE CANNOT BE LIT UNTIL THE 3

MINUTES HAVE ELAPSED.

1. COMMISSIONING THE APPLIANCE

1.1 Complete the Commissioning Checklist at the front of this

manual covering:

— Flue checks

— Gas checks

— Log layout - flame picture

For working pressure test, use the access panel at the gas

connection ensuring the burner is in position. Refer to

Installation Instructions, Section 3.

1.2 Upon completion of of the commissioning and testing of the

installation and correct operation of the appliance, the

installer must instruct the user how to operate the

appliance.

1.3 Guide the user through the User Instructions paying

particular attention to:

a) Regular servicing (Section 9 of the User Instructions).

b) Ventilation (Section 10 of the User Instructions) - point

out the ventilation positions where applicable.

c) Hot surfaces (Section 12 of the User Instructions).

INSTALLATION INSTRUCTIONS

INSTALLATION/COMMISSIONING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gazco Riva Nemos Coprecci Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info