Bedienungsanleitung Gazco Riva Vision Large MK1 Series Conventional Flue (Seite 15 von 36) (Englisch)

813415

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

1. Flue & Chimney Requirements

WHEN INSTALLING A FLUE SYSTEM PLEASE REFER

TOTHEMANUFACTURER’SINSTRUCTIONS.

The European chimney standards now describe chimneys

and flues by their temperature, pressure and resistance to

corrosion, condensation and fire. To identify the correct flue

system, the minimum flue specification is shown in the

Technical Specification. Existing chimneys are not covered

by this system.

The flue must be installed in accordance with all local and

national regulations and the current rules in force:

1.1 A flexible liner must be continuous from the appliance spigot

to the roof terminal.

1.2 The minimum effective height of the flue must be 3m (10').

1.3 The flue must be free from any obstruction.

1.4 Any damper plates must be removed or secured in the fully

open position and no restrictor plates fitted.

1.5 The chimney should be swept immediately before installing

the appliance, but it need not be swept if you can see the

chimney is clean and free from obstruction throughout.

2. Flue Options

Top Exit only - Twin Wall Rigid

 127mm(5”)

 ArangeofVitreousEnamelGlossBlackfluepipeis

availabletocomplimenttheRivaVision.Pleasecontact

your Gazco retailer for further information.

3. Gas Supply

This appliance is intended for use on a gas installation

with a governed meter.

3.1 Make sure local distribution conditions (identification of the

type of gas and pressure) and the adjustment of the

appliance are compatible before installation.

3.2 Ensure the gas supply delivers the required amount of gas

and is in accordance with the rules in force.

3.3 You can use soft copper tubing on the installation and soft

soldered joints outside the appliance and below the firebed.

3.4 A factory fitted isolation device is part of the inlet connection;

no further isolation device is required.

3.5 All supply gas pipes must be purged of any debris that may

have entered prior to connection to the appliance.

3.6 The gas supply enters through the silicone panel located on

the LEFT-HAND side of the outer box. Slit with a sharp knife

prior to passing the supply pipe through.

3.7 The gas supply must be installed in a way that does not

restrict the removal of the appliance for servicing and

inspection.

4. Ventilation

IMPORTANT: Ensure any national ventilation

requirements are taken into account during installation

of the appliance.

UK ONLY:

The Riva Vision has a nominal input not exceeding 7.0kW

and does not normally require any additional permanent

ventilation.

FOR THE REPUBLIC OF IRELAND REFER TO THE

RULESINFORCEFORVENTILATIONREQUIREMENTS.

5. Appliance Location

5.1 This appliance has been designed to stand on either a

hearth or an optional bench:

RVACLB100B - Riva Bench Low (100cm wide)

RVACB100B - Riva Bench (100cm wide)

RVACLB120B - Riva Bench Low (120cm wide)

RVACB120B - Riva Bench (120cm wide)

RVACLB140B - Riva Bench Low (140cm wide)

RVACB140B - Riva Bench (140cm wide)

5.2 To install the bench:

Follow Section 1, Installation - All Models in the installation

guide (PM205) supplied with the bench kit.

5.3 To secure the appliance to the bench:

You must consider where you place the appliance on the

bench before using the template, see Diagram 1.

Using the template provided with this appliance as a

guide to the final position of the appliance:

1. Mark and drill the holes.

2. Fix the two brackets to the bench. For details refer to

Installation Instructions, Section 2.

3. Position the appliance on the bench lining up the holes in

it's base with the fixing plates, see Installation Instructions,

Section 2.

Installation Instructions

Site Requirements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gazco Riva Vision Large MK1 Series Conventional Flue Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info