Bedienungsanleitung Gazco Steel Manhattan Log Conventional (Seite 11 von 32) (Englisch)

813401

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

1. Flue & Chimney Requirements

1.1 The chimney or flue system must comply with the rules in

force, and must be a minimum of 127mm in diameter. (5").

1.2 The minimum flue height for the appliance must be 3 metres

(10ft). Any horizontal flue run from the rear outlet must not

exceed 100mm from the back of the appliance.

1.3 The chimney or flue must be free from any obstruction. Any

damper plates must be removed or secured in the fully open

position, and no restrictor plates fitted.

1.4 The chimney must be swept prior to the installation, but it

need not be swept if it can be seen the chimney is clean and

unobstructed throughout its entire length.

NOTE: If it is intended to fit the stove into an existing

brick- built chimney a 5" (127mm) liner must be used.

Larger lined flues may work, but in some instances

could cause cold start flue problems resulting in

nuisance shutdown. Lined flues above 7" (175mm) are

not recommended.

The European chimney standards now describe chimneys

and flues by their temperature, pressure and resistance to

corrosion, condensation and fire. To identify the correct flue

system, the minimum flue specification is shown in the

Technical Specification. Existing chimneys are not covered

by this system.

2. Gas Supply

THIS APPLIANCE IS INTENDED FOR USE ON A GAS

INSTALLATION WITH A GOVERNED METER.

2.1 Before installation, ensure that the local distribution

conditions (identification of the type of gas and pressure)

and the adjustment of the appliance are compatible.

2.2 Ensure the gas supply delivers the required amount of gas

and is in accordance with the rules in force.

2.3 Soft copper tubing and soft soldered joints can be used but

must not be closer than 50mm to the base of the tray.

2.4 A means of isolating the gas supply to the appliance must

be provided independent of any appliance control.

2.5 All supply gas pipes must be purged of any debris that may

have entered prior to connection to the appliance.

2.6 The gas supply must be installed in a way that does not

restrict the removal of the appliance for servicing and

inspection.

Installation Instructions

Site Requirements

3. Ventilation

IMPORTANT: Ensure any national ventilation

requirements are taken into account during installation

of the appliance.

3.1 This appliance has a nominal input not exceeding 7.0kw and

therefore, does not normally require any additional

permanent ventilation.

3.2 If however, spillage is detected when commissioning the

appliance, there may be insufficient natural ventilation and

additional ventilation may be required.

FOR THE REPUBLIC OF IRELAND REFER TO THE

RULES IN FORCE FOR VENTILATION REQUIREMENTS.

4. Appliance Location

4.1 Building Regulations state this appliance must stand on a

non-combustible hearth that is at least 12mm thick and

projects 50mm minimum from the base of the appliance in

all directions, however Gazco recommend the hearth

extends to the following dimensions, see Diagram 1.

A = 1009mm

B = 525mm

C = 12mm

4.2 Do not install in a room that contains a bath or shower.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gazco Steel Manhattan Log Conventional Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info