Dear customer,
The DC2 ”S“ which you have purchased is one of our highest quality technical pro-
ducts. We have taken the greatest care in its manufacture to ensure that this
microprocessor controlled encoder reaches you in faultless condition. However in
the unusual event of suspected equipment failure please return the appliance
together with the enclosed warranty document to your dealer or direct to our
factory.
The extent of warranty exclusively refers to the free repair of malfunctions of the
appliance, which demonstrably are caused by faults in production or defective
material, inclusive of spare parts required for this purpose.
WARRANTY-DOCUMENT
On the below described encoder we grant a warranty of
2 years
Type: DC2 ”S“
Production date: ____________________________________________________
Sales date: ____________________________________________________
Dealers adress: ____________________________________________________
DIP 1 DIP 2 DIP 3
1x 2 min nightlight motor reverses motor starts
flashing period ~ 10 cm after immediately with
outside light safety stop outside light
2x 4 min nightlight motor reverses motor starts
flashing period completely after 3 s. after
outside light safety stop outside light
DIP switch 4 without function.
1
2
3
4
Description of the appliance
The DC2 ”S“ controller is suitable for use with tubular motors or geared drive units. It has
the facility for the connection of radio control or keyswitch.
Radio control (optional)
The radio receiver board is easily fitted into the controller. To program the transmitter:
1. Press the ”learning” key on the receiver unit momentarily. The control light beside
this key should begin to flash.
2. Press and hold the transmitter key. When the transmitter is programmed in, the
control light will give a steady glow. (The control light will extinguish after a few
seconds).
Antenna
The antenna (27 Mhz 0.5 or 0.75 mm
2
x 2.0m long) or (433 Mhz 0.5 or 0.75 mm
2
x 20cm
long) should be connected to the receiver unit as indicated, and then fixed along the wall
at about 1cm distance from the wall (this can be acheived using plastic conduit + clips).
Control function settings:
These are programmed by use of DIP-switches 1, 2 & 3.
When the relevant DIP-switch is switched on, it will flash for a 5 second period at either
1x or 2x flashes, and will then change to 2x or 1x. With reference to the table below, the
different functions are set simply by returning the switch to the OFF position when the
desired mode is indicated by the flashes.
