Bedienungsanleitung Wellis Easy 7 (Seite 6 von 108) (Englisch)

784849

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

Parts under electrical power – except those operating with

voltage not exceeding 12V - must be inaccessible for persons

in the spa. The grounded device must be connected to a

fixed socket with fixed wiring. Electrical parts – except

remote controllers – must be positioned so as not to fall into

the spa.

The electrical installation must meet the local standard

requirements.

To avoid electric shock do not use the spa in rain.

Water attracts children. Always place and lock the cover on

the spa after each usage.

Do not bury cables into the ground! Place the cables so that

lawnmowers, trimmers, and similar devices will not reach

them.

Do not force push the control panel up nor down and do not

place heavy objects on it after installation.

Keep pets away from the spa to avoid damage.

Do not use the device if there is the slightest chance of water

in the spa being frozen.

Only use accessories approved by us. The use of accessories

not approved by us may void the warranty.

Choking hazard. Particular attention need to be paid to

children during usage. To avoid accidents only allow children

to use this spa under adult supervision.

Never operate electrical devices in the spa or with wet body.

Do not place electrical devices (lamp, radio, television) within

a 1.5m radius of the spa.

Do not expose the spa to direct sunlight.

Only connect the spa to an earthed socket.

Risk of electric shock. Install the unit at least 1.5m (5 feet)

from any metal surfaces. You can install the unit 1.5m from

metal surfaces only if every metal surface is permanently

connected to a solid copper conductor

with a diameter of at least 6mm, which is connected to the

cable connector of a junction box reserved for that purpose.

To avoid injury never pour water warmer than 40°C directly

into the spa.

Effects of overheating: you cannot assess emergency situa-

tions, do not feel the temperature, do not feel the need to get

out of the spa, cannot get out of the spa; risk of fetal damage

in pregnant women, loss of consciousness, suffocation.

Do not use the spa alone.

Do not use the spa immediately after strenuous sport.

To prevent damage to the pump the spa can only be operat-

ed if it has been filled with water.

If you feel uncomfortably or sleepy, leave the spa immedi-

ately.

Never add water to the chemicals. Always be cautious when

adding chemicals to the spa water to avoid inhaling vapors

and possible effects of inhaling undiluted chemicals and

splatters.

Only place the spa on a surface that can support its weight.

INSPECT THE UNIT BEFORE USE. CONTACT THE SER-

VICE PROVIDER STATED IN THIS MANUAL IF ANY

OF THE PARTS WERE DAMAGED OR MISSING UPON

PURCHASE. ENSURE THAT THE PARTS OF THE UNIT

ARE THOSE WHICH YOU INTENDED TO BUY.

IN.CLEAR SAFETY WARNINGS

Beyond the previous warnings, please also pay attention to

the undermentioned ones

Read this manual carefully, always follow its instructions, and

retain it. This manual contains important information about

the installation, operation, and safety recommendations of

the in.clear unit. Safe installation and usage is your respon-

sibility.

The in.clear unit must be connected to a network protected

by a ground fault circuit interrupter (GFCI) of the maximal

nominal fault current value of 30mA.

Ensure that the entire power supply is turned off before the

in.clear unit is installed.

If the power cord is damaged, it must be replaced by the

manufacturer, an authorized service provider, or qualified

professionals to avoid emergencies.

Always use a proper electric cable for supply of current to the

in.clear unit.

When installing the in.clear Automatic Bromine Generator

local and international electrical regulations must be com-

plied with.

Clean or replace the filter cartridge at regular intervals, oth-

erwise part of the bromine produced by the in.clear unit will

be consumed by oxidation of contamination accumulated in

the filter.

DO NOT pour any other chemicals into the spa than the

recommended sodium bromide. DO NOT use any ozone or

UV disinfectant.

Operating the in.clear unit on lower sodium bromide level

shortens the life of the cells. Keeping sodium bromide and

bromine levels above the recommended level may lead to

corrosion of the spa components and cause damage to the

spa accessories.

Do not open the in.clear unit; it does not contain serviceable

parts

Product disposal: the in.clear unit must be disposed of in

accordance with local disposal regulations in force.

This device is not intended for use by persons (nor children)

with limited physical, sensory, or mental capabilities except if

these persons have received appropriate instruction on use

of the device from the person responsible for their safety.

The in.clear unit cannot be applied to in-ground sunken spas

as it may affect materials used in the construction.

The shut-off device must have fixed wiring in accordance

with the cabling regulations.

Showering is compulsory before each spa use.

The user is responsible for regular monitoring of the spa

water to ensure that enough bromine is available to reach

the appropriate cleaning level. Intensive spa use may require

higher bromine intake to always maintain appropriate

bromine level.

Always check the expiry date of the test kit, because after this

date the test results may be inaccurate.

For proper disinfection spas must periodically be completely

drained. The advised time period between full drains given in

days is calculated by dividing the capacity of the spa in litres

by the tenfold of the average daily users.

The in.clear unit is applicable for indoor spas, but NOT for

swimming pools.

SAFETY INSTRUCTIONS

Wellis Easy 7 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wellis Easy 7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info