Charging the batteries
Charge the batteries for at least 12 hours when charging
for the first time.
Note: DO NOT FORGET TO REGISTER YOUR
HANDSET WITH DECT BASE (AMPLIDECT COMBI
295 or AMPLIDECT295).
OVERVIEW
1. Incoming Call light
Flashes red slowly when receiving an incoming call.
2. Earpiece
3. Charger/Booster LED (
)
- Steady red when the handset battery is charging.
- Long flashes in red when the handset battery is low.
- Flashes red quickly when handset registration is in
progress.
- Flashes red slowly when the handset is not registered or
not in charger.
- Steady blue when the booster function is activated.
4. Photo speed dial keys
Your handset has four photo speed dial keys. It retrieves
the same set of photo or Direct Memory speed dial entries
stored in the AMPLIDECT295 or AMPLIDECT COMBI
295.
Press to dial a preset number.
5. Talk ON / Flash (
)
- Make or answer a call.
- Light Green when the handset is on earpiece mode.
- During a call , Press to access Recall feature (R).
6. TALK OFF (
)
- Hang up a call.
- Silence the ringer temporarily while the phone is ringing.
- Mute the paging tone.
7. SPEAKER (
)
- Make or answer a call using the speakerphone.
- Switch between the speakerphone and the earpiece.
- Light Orange when on speakerphone mode.
8. Microphone
9. Charging pole
10. Speakerphone
11. Battery compartment cover
12. VOL+ (
)
- Increase the listening volume up to 30dB amplification,
(Or the ringer Volume when in quiescent mode).
- Switch On/Off the receiver Booster function (LED bleu).
13. VOL- (
)
Decrease the listening volume. (Or the ringer volume
when in quiescent mode (until ringer turn OFF)).
HANDSET REGISTRATION
Base: First place the base of the AMPLIDECT295 or
AMPLIDECT COMBI 295 in Registration mode.
Handset: Replace Handset in charge on Pod, the red
LED flashes quickly to indicate registration in process.
You hear a confirmation tone when the registration
process completes. It takes up to 60 seconds to complete
the registration.
Note: Make this procedure if you doesn’t arrive to register
your handset. Quickly press [VOL+] [SPK] [VOL-] [SPK]
[VOL+] [VOL-] [SPK] in idle mode, then HS will have a
"Bi,Bi" tone.
BOOSTER MODE
During a call, when in boost mode, you can increase the
listening volume up to 30dB amplification.
- Press and Hold ( 2 seconds) the VOL+ button to activate
Boost mode (LED will be steady blue).
- Press and hold again the VOL+ button to cancel Boost
mode.(LED will go Off).
GUARANTEE
From the moment your Geemarc product is purchased,
Geemarc guarantee it for the period of two years. During
this time, all repairs or replacements (at our discretion)
are free of charge. Should you experience a problem then
contact our help line or visit our website at
www.geemarc.com.
The guarantee does not cover accidents, negligence or
breakages to any parts. The product must not be
tampered with or taken apart by anyone who is not an
authorized Geemarc representative.
The Geemarc guarantee in no way limits your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR
GUARANTEE AND MUST BE RETAINED AND
PRODUCED IN THE EVENT OF A WARRANTY CLAIM.
Please note: The guarantee applies to the United
Kingdom only.
DECLARATIONS:
CE Directives
Geemarc Telecom SA hereby declares that this
product is in compliance with the essential requirements
and other relevant provisions of the Radio and
Telecommunications Terminal Equipment Directive
2014/53/UE and in particular article 3 section 1a,1b and
section 2. The telephone does not operate if the line
current is lower than 18mA.
The CE declaration of conformity may be consulted at
www.geemarc.com
Electrical connection: The apparatus is designed to
operate from a 230V 50Hz supply only. (Classified as
hazardous voltage according to EN60950 standard). The
apparatus does not incorporate an integral power on/off
switch. To switch off the apparatus, disconnect the power
adaptor.
When installing the apparatus, ensure that the mains
power socket is readily accessible.
Recycling Directives
The WEEE (Waste Electrical and Electronic
Equipment) has been put in place for the products
at the end of their useful life are recycled in the best way.
When this product is finished with, please do not put it in
your domestic waste bin. Please use one of the following
disposal options:
- Remove the batteries and deposit them in an
appropriate WEEE skip.
Deposit the product in an appropriate WEEE skip.
- Or, hand the old product to the retailer. If you purchase a
new one, they should accept it.
Thus if you respect these instructions you ensure human
health and environmental protection.
For product support and help visit our website at
www.geemarc.com
telephone 01707 387602
or fax 01707 832529
QUGPhotoDECT295_En_A4_V1.1
