Stop the Alarm
Press S1 (the upper right button) or S2 (the lower right button) once while the alarm is vibrating. This will stop the vibration alarm.
Snooze Mode
The watch enters Snooze mode automatically if the alarm is not stopped (as described in the Stop the Alarm section above). In snooze
mode, the alarm will ring for 15 seconds every minute for 5 minutes unless S1 or S2 is pressed.
Alarm Vibrator Check
Press and hold S4 for 3 seconds to ensure the vibrating alarm is working.
SYNCHRONIZE WATCH HANDS
Synchronise Analogue Time with LCD Time
Press and hold S2 (the lower right button) for approximately 3 seconds. A flashing 12 H or 24 H will be displayed
Keep pressing S2 a number of times further until HAND is displayed on the LCD
Press and hold S1 for approximately 5 seconds until the second hand is spinning rapidly. Release S1
When the spinning second-hand is driving the minute and hour hands closer to 11:59, stop the second-hand with one press of S1.
Then, keep pressing S1 briefly but repeatedly until all 3 hands align at 12 0’ clock position (If you accidentally go past 12, start this process
again). When all hands are aligned at the 12 0’clock position press S2 button briefly, to confirm the LCD displays WAIT and the second hands
will spin rapidly until all 3 hands match the LCD time The watch will resume normal operation automatically.
TROUBLESHOOTING
Why is the analogue time different from the LCD time?
Sometimes hard knocks or vibrations can cause the watch hands to move irregularly, and therefore the incorrect time is displayed. However,
the internal clock will be keeping accurate time. The watch hands need to be recalibrated. Please go to Synchronize Analogue Time with LCD
Time section for details.
Why is the second hand jumping in 2 second intervals?
When the battery level is low your watch runs one step every 2 seconds and the “Low Battery” icon flashes telling you to recharge your watch.
When the “Low Battery icon” is flashing, the vibration alarm and other button functions are disabled. It is time to recharge your watch.
BATTERY CHANGE
Battery Type
This watch uses a ML2032 rechargeable battery. Only trained jewelers or watch specialists should fit new batteries to avoid any damage to
the watch. Your Guarantee may become invalid if you open up this watch!
Instructions to Trained Person re Opening up the Watch
Carefully open the watch at the back. Ensure not to break wires that connect the watch module with the vibrator.
Pick up the battery spring and make sure you are not losing the waterproof seal.
Take out the battery and insert a new one (take heed of battery polarity and ensure to insert the correct way up).
Push the battery spring down.
Before you put the case-back on again, make sure the waterproof seal is correctly in place.
After Battery Replacement
After battery replacement, the second hand starts to run. Then simply follow Synchronize Analogue Time with LCD Time instructions.
GUARANTEE
Guarantee
From the moment your Geemarc product is purchased, Geemarc guarantee it for the period of 2 years. The guarantee does not cover
accidents, negligence or breakage to any parts. Batteries and straps not covered under warranty. This watch is designed and manufactured to
withstand up to 3 bars, but it is not designed for wearing while swimming or diving. In those cases, the watch is not covered under warranty.
The Geemarc guarantee in no way limits your legal rights. The product is covered by the legal guarantee of conformity as provided by
applicable law.
Important: YOUR RECEIPT IS PART OF YOUR GUARANTEE AND MUST BE RETAINED AND PRODUCED IN THE EVENT OF A
WARRANTY CLAIM.
After Sales Telephone Number: +44 (0) 1707 372372
EC Declaration:
This product respects the CE Marking. The declaration of conformity may be consulted at www.geemarc.
Geemarc Télécom SA
Parc de I’Etoile
2 rue Galilée
59791 GRANDE SYNTHE CEDEX
FRANCE
