Bedienungsanleitung Gemini 7733 (Seite 2 von 3) (Englisch)

479869

Zoom out

Zoom in

Vorherige Seite

1/3

Nächste Seite

ALARM SYSTEM DESCRIPTION

Dear Customer, please read fully this manual and aquaint yourself with the

operation and the functions of your alarm system.

Below are described the alarm module functions:

! System arming and disarming by the original radio control.

! Acoustic arming/disarming signaling (excludable by programming).

! Optical arming/disarming signaling (required if the vehicle fails to flash its

indicators on remote lock and unlock).

! Perimetric protection.

! Volumetric protection (excludible by arming).

! Electrical engine immobiliser.

! Memory Led.

! Multifunction electronic key.

! Emergency disarming by electronic key.

NOTE: This manual covers the 7733 alarm system with all added accessories.

GEMINI 7732: Same as 7733 without self-powered battery.

OPERATING DESCRIPTION

COMPLETE ALARM ARMING

Press the lock button on the original radio control of the vehicle or insert the

electronic key into the specific receptacle.

Arming will be indicated by two short acoustic signals and by a number of

optical signals, (default vehicles manufacturer setting).

ALARM ARMING WITH VEHICLE MECHANICAL KEY

In some vehicles, when using the mechanical key for the door locking, the

alarm system will arm.

It is possible in some cases, when unlocking the vehicle by the mechanical key,

during the neutral time of arming, the alarm system will disarm.

For obvious safety reasons when the alarm is fully armed the system can only

be disarmed by remote control or by override procedure, not via the

mechanical door key.

ALARM ARMING WITH EXCLUSION OF VOLUMETRIC PROTECTION

This function allows the user to arm the system, with volumetric protection

excluded (leaving a window open)

To active this function, the system must be disarmed and the ignition switched

“OFF” and then proceed as follows:

! Turn the ignition “ON” and wait for one second the status led switches off

(the drivers door can be open or close at this point).

! Introduce the electronic key into the receptacle.

! Turn the ignition “OFF”.

NOTE: when an immediate re-arming of volumetric sensors is required, switch

the ignition “ON” and “OFF”.

! Press the lock button of the vehicle's original radio control or insert the

electronic key into the receptacle.

NOTE: rearming the alarm system will re-introduce volumetric sensors.

INHIBIT TIME

The inhibit arming time lasts for approxiately 25 seconds and is indicated by a

illuminated Led.

SYSTEM ARMED

After the inhibit time (about 25 sec.), the system is armed and it is ready to

detect any theft attempt.

When the system fully armed, the LED flashes.

After disarming the system, any occured attempt will be indicated by the alarm

with visual/acoustic signaling (see relative paragraph).

ALARM, INHIBIT TIME AND ALARM CYCLES

As mentioned before, the alarm will indicate any theft attempt by

optical/acoustic signals.

After the alarm has been triggered, before another alarm cause, there is a 5

second “neutral time”.

The alarm can trigger on each input circuit 5 cycles of 30 seconds.

The ignition key (+15/54) and the cut wire alarm signaling have no cycle

limitation.

ALARM DISARMING

Press the unlock button of the vehicle's original radio control.

Disarming is indicated by three short acoustic signals and by a number of

optical signals, which have been programmed by the vehicles manufacturer.

If an alarm condition has occurred, it will be signalled by five quick acoustic

signals.

See next paragraphs for possible causes and relative signaling.

ALARM MEMORY

When disarming the alarm, if the alarm beeps 5 times, it is possible to identify

the alarm cause by turning the ignition “ON” and look at the vehicle status

LED.

The LED will flash, showing the last alarm trigger condition.

The status led will illuminate for one second and two short acoustic signals

will indicate the exclusion of volumetric sensors.

Two acoustic signals and the number of optical signals that has been

programmed by the car's manufacturer will indicate that the system has

been armed.

PAGE. 2

PAGE. 3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gemini 7733 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info