Bedienungsanleitung General Electric DCVH485EK (Seite 10 von 108) (Englisch, Französisch, Spanisch)

646566

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips

Using the dryer.

Care and Cleaning of the Dryer

Dryer Interior and Duct: The interior of

the appliance and exhaust duct should be

cleaned once a year by qualified service

personnel.

The Exterior: Wipe or dust any spills or

washing compounds with a damp cloth.

Dryer control panel and finishes may be

damaged by some laundry pretreatment

soil and stain remover products. Apply

these products away from the dryer. The

fabric may then be washed and dried

normally. Damage to your dryer caused

by these products is not covered by your

warranty.

Do not touch the surface or the display

with sharp objects.

The Lint Filter: Clean the lint filter before

each use. Remove by pulling straight up.

Open the filter and run your fingers across

the filter. A waxy buildup may form on the

lint filter from using dryer-added fabric

softener sheets. To remove this buildup,

wash the lint screen in warm, soapy

water. Dry thoroughly and replace. Do not

operate the dryer without the lint filter

in place.

Vacuum the lint from the dryer lint

filter if you notice a change in dryer

performance.

Stainless Steel: To clean stainless steel

surfaces, use a damp cloth with a mild,

nonabrasive cleaner suitable for stainless

steel surfaces. Remove the cleaner

residue, and then dry with a clean cloth.

The stainless steel used to make

the dryer drum provides the highest

reliability available in a GE dryer. If

the dryer drum should be scratched or

dented during normal use, the drum

will not rust or corrode. These surface

blemishes will not affect the function

or durability of the drum.

The Exhaust Hood: Check with a mirror

that the inside flaps of the hood move

freely when operating. Make sure that

there is no wildlife (birds, insects, etc.)

nesting inside the duct or hood.

Always follow fabric manufacturer’s care label when laundering.

Tumble

dry

Dry

Normal

Permanent Press/

wrinkle resistant

Gentle/

delicate

Do not tumble dry

Do not dry

(used with

do not wash)

Heat

setting

High

Medium

Low

No heat/air

Special

instructions

Line dry/

hang to dry

Drip dry

Dry flat

In the shade

Dry Labels

Sorting and Loading Hints

As a general rule, if clothes are sorted

properly for the washer, they are sorted

properly for the dryer. Try also to sort items

according to size. For example, do not dry

a sheet with socks or other small items.

Do not add fabric softener sheets once

the load has become warm. They may

cause fabric softener stains. Bounce

Fabric Conditioner Dryer Sheets have

been approved for use in this dryer when

used in accordance with the manufacturer’s

instructions.

See below for lint filter cleaning instructions.

Do not overload. This wastes energy and

causes wrinkling.

Do not dry the following items: fiberglass

items, woolens, rubber-coated items, plastics,

items with plastic trim and foam-filled items.

Fabric Care Labels

Below are fabric care label “symbols” that

affect the clothing you will be laundering.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

General Electric DCVH485EK Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info