Bedienungsanleitung General Electric DCVH485EK (Seite 33 von 108) (Englisch, Französisch, Spanisch)

646566

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

GEAppliances.com

Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions

PROBLEM Possible Causes What To Do

No numbers displayed Dryer is continuously • This is normal. When the dryer senses a low level of

during cycle, only lights monitoring the amount of moisture in the load, the dryer will display the dry time

moisture in the clothes remaining.

Time Remaining The estimated time may change • This is normal.

jumped to a when a smaller load than usual

lower number is drying

Cannot make a The DRYNESS LEVEL, TEMP • This is normal.

selection and the or OPTION that you are

dryer beeps twice trying to select is incompatible

with the chosen dry cycle

Dryer is running but The EXTEND TUMBLE • This is normal. During extended tumbling, the time

00 is displayed in option was chosen remaining is not displayed. The extended tumbling

Time Remaining option lasts approximately 20 minutes. It will then

tumble intermittently for approximately 70 minutes.

Clean Lint Filter (message) POWER button was activated • Press START/PAUSE to begin a dry cycle and the message

will disappear.

Dryer doesn’t heat Fuse is blown/circuit breaker • Check the building’s fuse/circuit breaker box and

is tripped; the dryer may tumble replace both fuses or reset both breakers. Your dryer

but not heat may tumble if only one fuse is blown or one breaker

tripped.

Inconsistent drying times Type of heat • Drying time will vary according to the type of heat used.

If you recently changed from an electric to a gas

(natural or LP) dryer, or vice versa, the drying time

could be different.

Type of load and • The load size, types of fabric, wetness of clothes and the

drying conditions length and condition of the exhaust system will affect

drying times.

Glow at the rear Heaters behind the drum • This is normal. Under certain drying conditions and

of the drum room ambient lighting, the glow of the heaters may be

visible at the rear of the drum.

Clothes are still wet The door was opened mid-cycle. • A dry cycle must be reselected each time a new load

and dryer shut off The load was then removed from is put in.

after a short time the dryer and a new load put in

without selecting a new cycle

Small load • When drying 3 items or less, choose SPEED DRY or

TIMED DRY.

Load was already dry except • Choose SPEED DRY or TIMED DRY to dry damp collars

for collars and waistbands and waistbands. In the future, when drying a load with

collars and waistbands, choose MORE DRY.

Dryer is not level • Move dryer to an even floor space or adjust leveling legs

as necessary until even.

Clothes are wrinkled Overdrying • Select a shorter drying time.

• Remove items while they still hold a slight amount of

moisture. Select a LESS DRY or DAMP setting.

Letting items sit in dryer after • Remove items when cycle ends and fold or hang

cycle ends immediately, or use the EXTEND TUMBLE option.

Overloading • Separate large loads into smaller ones.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

General Electric DCVH485EK Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info