Bedienungsanleitung General Electric GFDS175 (Seite 17 von 44) (Englisch, Spanisch)

646570

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Troubleshooting Tips

Save time and money! Review the charts on the following pages,

or visit GEAppliances.com. You may not need to call for service.

Before you call for service…

PROBLEM Possible Causes What To Do

Dryer shakes or Some shaking/noise is normal. • Move dryer to an even floor space, or adjust leveling legs

makes noise Dryer may be sitting unevenly as necessary until even.

Clothes take too long Improper or obstructed ducting • Check the Installation Instructions to make sure the

to dry dryer venting is correct.

• Make sure ducting is clean, free of kinks and

unobstructed.

• Check to see if outside wall damper operates easily.

Improper sorting • Separate heavy items from lightweight items (generally,

a well-sorted washer load is a well-sorted dryer load).

Large loads of heavy fabrics • Large, heavy fabrics contain more moisture and take

(like beach towels) longer to dry. Separate large, heavy fabrics into smaller

loads to speed drying time.

Controls improperly set • Match control settings to the load you are drying.

Lint filter is full • Clean lint filter before every load.

Blown fuses or tripped circuit • Replace fuses or reset circuit breakers. Since most

breaker dryers use 2 fuses/breakers, make sure both are

operating.

Overloading/combining loads • Do not put more than one washer load in the dryer at

a time.

Underloading • If you are drying only one or two items, add a few items

to ensure proper tumbling.

The Dry dryness level Load consists of a mixture • When combining heavy and light fabrics in a load,

was chosen but load is of heavy and light fabrics choose More Dry.

still damp

Exhaust system is blocked • Inspect and clean exhaust system.

Control buttons not Controls accidentally put in • Press Start/Pause.

responding service mode

Controls accidentally put in • Hold the Lock Control button for 3 seconds to unlock the dryer.

lock mode

Controls performed an • Reset the in-house breaker.

incorrect operation

Dryer doesn’t start Control panel is “asleep” • This is normal. Press Power to activate the control panel.

Dryer is unplugged • Make sure the dryer plug is pushed completely into

the outlet.

Fuse is blown/circuit breaker • Check the building’s fuse/circuit breaker box and

is tripped replace fuse or reset breaker. NOTE: Electric dryers

use two fuses or breakers.

Dryer was accidentally paused • If the light on the Start/Pause button is flashing,

when starting Delay Dry the dryer is paused. Press Start/Pause to restart

the countdown.

No numbers displayed Dryer is continuously • This is normal. When the dryer senses a low level of

during cycle, only lights monitoring the amount of moisture in the load, the dryer will display the dry time

moisture in the clothes remaining.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

General Electric GFDS175 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info