Bedienungsanleitung General Electric GTD86 (Seite 7 von 36) (Englisch, Spanisch)

646564

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

My Cycle Settings

As the cycle selector knob is turned, the Time (Timed Dry), Level (Dryness Level), and Temp (Temperature) settings

change to automatic pre-set default settings. If you desire a different setting, press the appropriate button(s). Then

press and hold the My

Cycle Settings button for 3 seconds. The button light will turn on and the dryer will save these

settings for that knob selection. In the future, when you turn the selector knob to that cycle, your settings will be

automatically recalled.

To temporarily (for this load) return to the pre-set default settings, depress the My

Cycle Settings button for 1/2

second. The button light will turn off and the options will change back to these defaults. To make these default settings

permanent, hold the My

Cycle Settings button again for 3 seconds to make them your preferred settings (the button

light will turn back on). NOTE: Volume level cannot be set for My

Cycle Settings.

Volume

Use the Volume button to change the volume of the end of cycle and control signals. Press the button until you reach the

desired volume (low-med-high) or off. The clothes should be removed when the beeper goes off so wrinkles do not set in.

NOTE:

• Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles will not set in.

• Use the Volume especially when drying fabrics like polyester, knits and permanent press. These fabrics should be removed

so wrinkles will not set in.

Drum Light

The drum light will go on if the Drum Light button is pushed or the door is opened. It will stay on until the door is shut or the

Drum Light or Power button is pushed.

Lock Controls

You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a

cycle. Children cannot accidentally start the dryer by touching buttons with this option selected.

To lock the dryer controls, press and hold the Lock Controls button for 3 seconds. The control lock icon will light up when locked.

To unlock the dryer controls, press and hold the Lock Controls button for 3 seconds.

NOTE: The Power button can still be used when the machine is locked.

eDry

Available for Bulky Items, Towels/Sheets, Cottons, Mixed Loads, Jeans, Casuals/Easy Care, Active Wear, and Delicates.

When the eDry button is pressed, cycle settings change to reduce the total energy consumption of the selected sensor cycle.

NOTE: Cycle times will change when eDry is selected. The eDry option will default to on for Cottons. For optimal energy

savings, turn eDry on. For optimal drying times, turn eDry off. NOTE: Energy savings will vary across loads and cycles.

The Efficiency Monitor lights display the relative energy use of your selected cycle and options. They are provided as an

energy guide and range from Good (1 light) to Better (5 lights). Cycle (time), dryness level, temperature, and additional tumble

options can increase or decrease your energy efficiency. Some special cycles will not provide a display.

GEAppliances.com

Options

Delay Dry

As the Delay Dry button is repeatedly pressed, the delay time sets to from 1 to 9 hours, and back to clear (0). After selecting

the delay time, press Start and the delay time will count down the time remaining until the cycle starts.

If the Delay Dry button is pressed for 3 seconds, it clears (regardless of the delay time) or terminates a delaying cycle.

Extended Tumble

Use this option to minimize the wrinkles in clothes. It provides 1 hour of no-heat tumbling after the clothes are dry. If you are

using the cycle Volume and you select the Extended Tumble option, a signal will sound at the end of the drying time and

every 5 minutes during the Extended Tumble cycle. This will remind you that it is time to remove the clothes.

Damp Alert

This option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. The

Damp Alert will only beep when this option is selected (but the dry cycle will keep running). Removing clothes and hanging them

when they are damp, can reduce the need to iron some items. The light beside the button will be lit when Damp Alert is on.

Rack Dry

Rack Dry is only allowed for timed cycles (Timed Dry & Air Fluff). The light turns off if cycle knob is turned to a non-timed cycle.

Temperature

High For regular to heavy cottons.

NOTE: Steam Dewrinkle and Steam Refresh require the High temperature setting.

Medium For synthetics, blends, delicates and items labeled permanent press.

Low For delicates, synthetics and items labeled tumble dry low.

Extra Low

For delicates, synthetics and items labeled tumble dry low.

No Heat For fluffing items without heat. For use only with the Timed Dry cycles.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

General Electric GTD86 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info