Bedienungsanleitung General Electric PGCS1 (Seite 7 von 136) (Englisch, Französisch, Spanisch)

503061

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

Water Filter Cartridge

The water filter cartridge is located in the back

upper right corner of the refrigerator

compartment.

When to Replace the Filter

There is a replacement indicator light for the

water filter cartridge on the temperature display.

This light will turn orange to tell you that you

need to replace the filter soon. The filter

cartridge should be replaced when the

replacement indicator light turns red or if the

flow of water to the dispenser or icemaker

decreases.

Installing the Filter Cartridge

If you are replacing the cartridge, first

remove the old one by slowly turning it to

the left. DO NOT pull down on the cartridge.

A small amount of water may drip down.

CAUTION: If air has been trapped

in the system, the filter cartridge may be ejected

as it is removed. Use caution when removing.

Remove the protective foil from the end of

the cartridge.

Fill the replacement cartridge with water

from the tap to allow for better flow from the

dispenser immediately after installation.

Lining up the arrow on the cartridge and the

cartridge holder, slowly rotate the cartridge

clockwise until it stops. When the cartridge is

properly installed, you will feel it “click” as it

locks into place. Do not overtighten.

Run 1

⁄2 gallons (about 3 minutes) from the

dispenser to clear the system and prevent

sputtering. See To Use the Dispenser section.

Press and hold the RESET WATER FILTER

pad (on some models) for 3 seconds.

NOTE: A newly-installed water filter cartridge

may cause water to spurt from the dispenser.

Filter Bypass Plug

You must use the filter bypass plug when a

replacement filter cartridge is not available. The

icemaker will not operate without the filter or

filter bypass plug.

Replacement Filters:

For the maximum benefit of your filtration

system, GE recommends the use of GE branded

SmartWater filters only. Using GE branded filters

in GE and Hotpoint refrigerators provides optimal

performance and reliability. GE branded

SmartWater filters are always the right choice

because they are patented and designed

specifically for GE products. GE SmartWater

filters meet rigorous industry NSF standards for

safety and quality that are important for

products that are filtering your water. GE has

not qualified non-GE branded filters for use in GE

and Hotpoint refrigerators and there is no

assurance that non-GE branded filters meet GE’s

standards for quality, performance and

reliability.

To order additional filter cartridges

in the United States, visit our Website,

GEAppliances.com, or call GE Parts and

Accessories, 800.626.2002.

Filter Model MWF

Customers in Canada should consult

the yellow pages for the nearest Mabe Service

Center.

About the water filter. (on some models)

(on some models)

Cartridge

Holder

Cartridge

Holder

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

General Electric PGCS1 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info