Bedienungsanleitung Gerlach GL 2829 (Seite 5 von 76) (Alle Sprachen)

797663

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

because water proximity presents risk, even if the device is turned off.

20. Never use this device close to water, e.g.: Under shower, in bathtub, or above sink

ﬁlled with water.

21. If the device utilises a power adaptor, do not cover it, because this can cause a

dangerous temperature rise and can damage the device. Always connect the power

adaptor cable to the device, and then connect the power adaptor to the power socket.

22. The cutting scissors are very sharp. Use caution when assembling, dismantling and

cleaning. Do not touch any elements of the moving blade during the operation!

23.DO NOT CHARGE THE BATTERY FOR LONGER THAN 48 HOURS – this can cause

irreversible damage to the battery.

16. Do not allow the device or power adaptor to wet. If the device falls into water,

immediately remove the power plug or power adaptor from the socket. If the device is

powered, do not put hands in the water. Have the device checked by the qualiﬁed

electrician before using it again.

18. The device has to be turned off after every use.

15.If using the device in bathroom after use remove the power plug from the socket,

17. Do not touch the device or power adaptor with wet hands.

14.In order to provide additional protection, it is recommended to install residue current

device (RCD) in the power circuit, with residual current rating not more than 30 mA.

Contact professional electrician in this matter.

19. Do not leave switched on equipment or adapter without supervision.

To begin charging plug the power cord into the charging Socket (6), and the charger into a 220-240V~ 50/60Hz mains power outlet.

The charging time is about 2 hours. After that the product is full charged, the running time is about 210 minutes.

24. The charging process should be conducted in temperatures between 5-35 degrees

Celsius.

After the battery is fully charged , there will be a “beep” and the battery capacity reminder (5c) will show 100% and the charging light

(5d)will blink at the same time.

PRODUCT DESCRIPTION:

5. LCD Display 5a. Oil Indicator 5b. Speed Indicator 5c. Battery Remaining Capacity 5d. Charge Indicator

25.Do not wash the blades in water.

1. Blade Head 2. Cutting Length Switch 3. Speed button 4. Power Button / Safety Lock

26.Only change comb attachments when the device is switched off.

6 Charging Socket 7. Combs 7a. Cleaning Brush 7b. Oil bottle 7c. Cape

CHARGING THE BATTERY:

When plug the power adapter into the socket, there will be a “beep” and the charging indicator (5d) will start blinking from bottom to

top.

Note: When it runs out of battery, you can use it while charging.

When the battery reaches 10%, 5% 0%, it will beep 3 times. When the battery reduces to 5%, the charging indicator (5d) will start

blink

Motor speed range : 5 speed levels are available 5000-7000 RPM

Every time you press “+” or “-“ button (3), it will adjust 500 RPM (5b)

POWER BUTTON / SAFETY LOCK (4)

Press the power button (4) to turn it on or off

SPEED CONTROL BUTTON (3) Speed Indicator (5b)

Press and hold the power button (4) for 3 seconds, to turn the safety lock on or off

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gerlach GL 2829 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info