Bedienungsanleitung Ghibli AS6 (Seite 14 von 88) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

505268

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

ITEN

EN - 2

USING THE APPLIANCE

N.B.

The appliance can only be used if the pa-

per bag is inserted correctly.

- The appliance is equipped with wheels

and during use can be dragged along us-

ing the hose.

To lift it up, insert your fingers into the

handle (14 Fig. 8) on the top of the cover.

Switching on the appliance

Insert the plug (15 Fig. 9) into the socket.

- Press the switch (16 Fig. 10), which lights

up, to switch the appliance on.

- When the light (17 Fig. 10) comes on, this

indicates that the paper bag is full and

must be replaced.

N.B.

The suction force can be adjusted using the

selector (18 Fig. 11) located on the ergonom-

ic handle (9 Fig. 11).

Opening up the window (19 Fig. 11) gives

lower suction power.

Using the telescopic tube

(if present)

- The length of the telescopic tube (20 Fig.

12) can be adjusted as follows:

- To lengthen the tube, press down on the

ring nut (21 Fig. 12) and simultaneously

extract the top part (22 Fig. 12) of the

tube. Once the required length has been

obtained, release the ring nut (21 Fig. 12)

the tube will lock into the nearest locking

position;

- To shorten the telescopic tube, use one

hand to push the ring nut (21 Fig. 12)

down and the other to reinsert the top

tube (22 Fig. 12) into the lower sleeve (23

Fig. 12).

Switching off the appliance

- Press the switch (16 Fig. 10) to switch off

the appliance.

- Remove the plug (15 Fig. 9) from the

socket.

- Wind up the cable (24 Fig. 13) and hook

it in position then couple the tube (9 Fig.

13) to the joint.

CLEANING AND

MAINTENANCE

DANGER:

Before performing any maintenance, un-

plug the appliance from the mains.

Removing and replacing the paper

dust bag

- Move the lever (1 Fig. 1) and remove the

cover (2 Fig. 1).

- Remove the suction hose by turning the

sleeve (6 Fig. 4) in an anti-clockwise di-

rection.

- Remove the paper dust bag (3 Fig. 2) and

replace it as described previously.

- Reassemble everything proceeding in re-

verse order compared to assembly.

Checking and cleaning the cartridge

filter

- The filter cartridge (25 Fig. 14) is pressed

into a special support. In order to remove

it, it must be lifted up.

- Clean the filter (25 Fig. 15) from the in-

side out with a blast of air. If there is too

much dirt, it must be replaced.

- Reassemble everything proceeding in re-

verse order compared to assembly.

Checking and cleaning the safety

filter

- Remove the filter cartridge (25 Fig. 14)

then remove the filter (26 Fig. 16) and

clean it with a blast of air.

The filter can be washed in warm water

and must only be replaced once it is com-

pletely dry. If it is too dirty, replace it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ghibli AS6 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info