623684
44
Zoom out
Zoom in
Vorherige Seite
1/57
Nächste Seite
86
87
13.1.2 Installing the front wheel
1. If your bike has a disc brake, remove the transport lock from the brake pistons.
2. Pick up the bike with the handlebars.
3. Position the hub of the front wheel under the fork ends of the front-wheel fork.
4. With disc brake: Insert the wheel so that the brake disc slides smoothly between the brake pads.
5. Lower the fork carefully until the axle is flush with the stop of the fork ends on the left and right.
6. Close your quick-release or thru axle according to section 8.6.1.2, Closing the quick-release axle or 8.6.2.2,
Closing the thru axle.
7. If your front wheel has a hub dynamo, connect the plug-in contact between the hub dynamo and cables.
8. Press the front wheel brake several times with the bike standing still.
9. Lift up the bike by the handlebars and turn the front wheel by hand. If a brake pad is in contact with the
brake disc or a brake block with the wheel rim, this can indicate incorrect mounting of the hub in the
fork dropouts. In this case, apply the brakes to the front wheel, open the quick-release or thru axle and
shake the front wheel back and forth lightly (sideways to the direction of travel). Repeat the installation
from point 6. If there is no improvement, please contact your specialist bicycle dealer immediately.
10. If your bike has a hub dynamo, check that the lights are working correctly.
(See section 7.10, Inspecting the lighting system.)
13.1.3 Dismantling the rear wheel
1. On the rear wheel, switch to the smallest sprocket of the sprocket assembly
(see section 8.4.1.2, Switching to a smaller chainring/sprocket).
2. Operate the rear brake until the rear wheel comes to a complete stop.
3. Open the lever of your quick-release or thru axle according to section 8.6.1.1, Opening the quick-release
axle or 8.6.2.1, Opening the thru axle.
4. Open your rim brake in accordance with section 13.1.5, Opening and closing the brakes.
5. Raise the bike at the rear end and push the gear shift mechanism to the rear. In this position, push the
rear wheel with alight pressure towards the opening in the frame.
44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ghost Bikes PathRIOT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Ghost Bikes PathRIOT

Ghost Bikes PathRIOT Bedienungsanleitung - Deutsch - 57 seiten

Ghost Bikes PathRIOT Bedienungsanleitung - Holländisch - 57 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info