2
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk
of electric shock by providing an escape wire for the electric current. This appliance is equipped
with a cord having a earthing wire with a earthing plug. The plug must be plugged into an outlet that
is properly installed and earthed.
WARNING: Improper use of the earthing plug can result in a risk of electric shock. Consult a
qualified electrician or serviceman if the earthing instructions are not completely
understood, or if doubt exists as to whether the appliance is properly earthed. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-
blade earthing plug, and a 3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord should be equal to or greater
than the electrical rating of the appliance.
INSTALLATION
Steady, flat location
This oven should be set on a steady, flat surface. This oven is designed for counter top use
only.
Leave space
All air vents should be kept a clearance. If all vents are covered during operation, the oven may
overheat and, eventually, oven failure. The minimum height of free space necessary above the
top surface of the oven is minimum 100mm.
Away from radio and TV sets
Poor television reception and radio interference may result if the oven is located close to a TV,
Radio antenna, feeder and so on.
Position the oven as far from them as possible.
Away from heating appliance and water taps
Keep the oven away from hot air, steam or splash when choosing a place to position it, or the
insulation might be adversely affected and breakdowns occur.
Power supply
• Check your local power source. This oven requires a current of approximately 6 amperes,
220V 60Hz.
• Power supply cord is about 1.1 meters long.
• The voltage used must be the same as specified on this oven. Using a higher voltage may
result in a fire or other accident causing oven damage. Using low voltage will cause slow
cooking. We are not responsible for damage resulting from use of this oven with a voltage of
ampere fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
a similarity qualified person in order to avoid a hazard.
Examine the oven after unpacking for any damage such as:
A misaligned door, Broken door, A dent in cavity. If any of the above are visible, DO NOT
INSTALL, and notify dealer immediately.
Do not operate the oven if it is colder than room temperature.
(This may occur during delivery in cold weather.) Allow the oven to become room temperature
before operating.
1
2
3
4
5
6
7
GMO-33(¿ )-1A5A9P 02.6.18 10:28 AM ˘`2
