Bedienungsanleitung Gigaset A410A (Seite 17 von 24) (Englisch)

580052

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Gigaset A410_A410A / IM_MEA en / A31008-M2402-R151-2-UZ19 / Bali_MEA_ar-fa.fm / 02.09.2013

Template Bali, Version 1, 16.02.2012

General specifications

Questions and answers

If you have any queries about the use of your telephone, visit our website at www.gigaset.com/service

for 24-hour support. The table below contains a list

of common problems and possible solutions.

Contact with liquid

If the handset has come into contact with liquid:

1 Switch the handset off and remove the battery immediately.

Allow the liquid to drain from the handset.

3 Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry,

warm pl

ace for at least 72 hours (not in a microwave, oven etc.).

4 Do not switch on the handset again until it is completely dry.

hen it has fully dried out, you will usually be able to use it again.

Authorisation

This device is intended for analogue phone lines outside the European Economic Area (with the exception of Switzer-

land) depending on national type approval.

Country-specific requirements have b

een taken into consideration.

We, Gigaset Communications GmbH, declare that this device meets th

e essential requirements and other relevant reg-

ulations laid down in Directive 1999/5/EC.

A copy of the Declaration of Conformity is av

ailable at this Internet address:

www.gigaset.com/docs

DECT standard is supported

GAP standard is supported

Range up to 300 m outdoors, up to 50 m indoors

Base station power supply 230 V ~/50 Hz

Environmental conditions in operation +5 °C to +45 °C, 20% to 75% relative humidity

Problem Cause Solution

Nothing appears on

e di

splay.

The handset is not switched on.

The batteries are flat.

Press the end call key a for approx. 5 seconds or place

the handset in the base station.

Charge or replace the batteries.

No wireless connec-

tion to the base sta-

tion, Ba

se fla

shes in

the display.

The handset is outside the range of

the ba

se station.

he base station is not turned on.

Move the handset closer to the base station.

Check the mains connector on the base station

¢ page 4.

The display shows

Regist

er HS or Put

into base.

Handset has not been registered

ith the base station or has been

de-registered.

¢ page 12.

Handset does not

ring

The ring tone is deactivated.

The phone only rings if the phone

numbe

r has been transferred.

The phone does not ring in a spe-

cific time period.

Activate the ring tone

¢ page 15.

Activate the ring tone for anonymous calls

¢ page 14.

Deactivate the "Time Control" or change the time period

¢ page 14.

You cannot hear a

ringe

r/dialling tone

from the fixed line

network.

The phone cord supplied has not

bee

n used or has been replaced by

a new cord with the wrong jack

connections.

Please always use the phone cord supplied or ensure

at the pin connections are correct when purchasing

from a r

etailer: 3-4 assignment of telephone leads/

EURO CTR37.

Error tone sounds

ter system PIN

prompt.

PIN forgotten.

The system PIN you have entered is

correct.

Reset the system PIN to the default 0000 ¢ page 15.

All handsets are de-registered. All settings are reset.

All lists a

re deleted.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gigaset A410A Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info