Bedienungsanleitung Gigaset C460 (Seite 29 von 36) (Englisch)

580357

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Appendix

Gigaset C460 / BT / A31008-M1706-L151-2-7619 / appendix.fm / 20.2.06

Appendix

Symbols and typographical

conventions used

This section explains the meaning of certain

symbols and typographical conventions that

are used in this user guide.

~ Enter digits or letters.

§Menu§ The display functions currently in

the bottom display line are shown

in reversed highlights. Press the

relevant display key to launch the

function.

q Press the top or bottom of the con-

trol key, e.g. when scrolling.

c / Q / P etc.

Press the illustrated key on the

handset.

External Calls / Internal Calls (example)

Select one of the menu functions

(External Calls or Internal Calls) from

the list and press

§OK§.

§Menu§ ¢ Audio Settings ¢ Ringer Melody

(example)

Press

§Menu§. Select Audio Settings

using

q and press §OK§. Select

Ringer Melody using

q and press

§OK§.

Care

¤ Wipe the base station and handset with a

damp cloth (do not use solvent) or an anti-

static cloth.

Never use a dry cloth. This can cause static.

Contact with liquid

If the handset has come into contact with liq-

uid:

¤ Switch the handset off and remove the

batteries immediately.

¤ Allow the liquid to drain from the handset.

¤ Pat all parts dry, then place the handset with

the battery compartment open and the key-

pad facing down in a dry, warm place for at

least 72 hours (not in a microwave, oven

etc.).

¤ Do not switch on the handset again until

it is completely dry.

When it has fully dried out, you will normally be

able to use itagain.

Questions and answers

If you have any questions about using your

phone, visit us anytime at www.siemens.com/

gigasetcustomercare. The table below contains

a list of common problems and possible solu-

tions.

The display is blank.

1. The handset is not switched on.

¥ Press and hold the end call key a.

2. The battery is flat.

¥ Charge the battery or replace it (page 4).

The handset does not respond to a key press.

The keypad lock is activated.

¥ Press and hold the hash key

(page 10).

Base is flashing in the display.

1. The handset is outside the range of the base sta-

tion.

¥ Move the handset closer to the base.

2. The base station is not switched on.

¥ Check the base station mains adapter

(page 4).

Handset does not ring.

The ringtone is switched off.

¥ Activate the ringtone (page 23).

You cannot hear a ringtone/dialling tone.

Base station's phone cord has been replaced.

¥ When purchasing a new cord, ensure that it has

the correct pin connections (page 4).

The incoming call number is not displayed

although CLIP (page 9) is set.

Phone number identification is not enabled.

¥ The caller should ask his network provider to ena-

ble Calling Line Identification (CLI).

You hear an error tone when keying an input

(a descending sequence of tones).

Action has failed/invalid input.

¥ Repeat the operation.

Watch the display and refer to the operating

instructions if necessary.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gigaset C460 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gigaset C460

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info