Bedienungsanleitung Gira 0389 (Seite 20 von 24) (Englisch)

606977

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Normal display (n)

This parameter is used to select the normal display of the controlling

device. This information is always displayed on the display whenever no

menu has been selected and no holiday settings are active.

1. The + and - buttons can be used to change to one of the operating

modes listed below.

2. S activates it.

* Preset in our works

Operating mode (b)

This parameter allows individual selection of the function for the room

temperature controller. This is used to specify the sensor selection for

temperature controlling, the mode of operation (heating/cooling) and the

limiting function.

1. The + and - buttons can be used to change to one of the operating

modes listed below.

2. S activates it.

* Preset in our works

Differential gap (d)

This parameter defines the differential gap (hysteresis) of the controlling

function.

1. The + and - buttons can be used to select the value.

2. S activates the value.

The relay is switched off if the current temperature lies over the setpoint

temperature by the value set here (Heating operating mode).

The relay is activated again if the actual temperature lies below the

setpoint value by the value set here (Heating operating mode).

The switching difference is set in our works to ±0.2 °C

Limiting temperature (G)

This parameter allows the setting of an individual limitation of the floor

temperature. If the limiting function is activated (operating mode with

limiting function selected), the relay is deactivated as soon as the

temperature measured at the external sensor exceeds the temperature

set here (heating).

In cooling mode the relay is deactivated as soon as the measured

temperature lies below the set limiting temperature.

1. The + and - buttons can be used to set the limitation.

2. S activates the limitation.

The setting range amounts to +5 °C to +55 °C. The limiting temperature

is set in our works to +45 °C

The limiting function does not have a differential gap, so that switching is

carried out immediately if the value exceeds the upper or lower limit.

Temperature at the external sensor (F)

If an operating mode which requires an external sensor is selected, the

current temperature value is displayed under this menu item.

No change can be carried out at this value.

If an operating mode which only operates with the internal sensor is

selected, "--.--" is displayed.

Normal display Display

Current time of day Clock *

Current setpoint temperature SETPOINT

Current actual temperature Actual

Reference

variable

Operating

mode

Floor temperature limit Display

Internal sensor Heating --- I.H*

Internal sensor Cooling External sensor

IE.C

External sensor Cooling --- E.C

Internal sensor Cooling --- I.C

Internal sensor Heating External sensor IE.H

External sensor Heating --- E.H

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gira 0389 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gira 0389

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info