Bedienungsanleitung Globe Fire Eros II (Seite 3 von 8) (Englisch)

814062

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

1. INSTALLATION OF STOVE.

The stove is ready for use and can be connected to the chimney with the flue pipe. If possible, connect the flue pipe, keeping it short, straight

or slightly at an angle to the chimney.

Seal the connection (heat resisting fire rope). When fitting the legs do not drag or push the stove but lift it (the legs could break off).

Connect the external air flow by using a pipe.

National or European standards, including local standards and any fire regulations must be complied with. Ensure that there is sufficient air

flow before burning wood. This is particularly important in well insulated houses and those with a mechanical ventilation system.

To ensure your chimney has the correct measurements it is possible to measure it. Ask your chimney sweeper for advice.

Before placing the stove into position check to see if the floor can take the weight. When in doubt place the stove on a large slab of stone

or marble to divide the weight.

2. GENERAL FIRE SAFETY INSTRUCTIONS.

During wood burning, high temperatures are reached make it impossible to touch the top, sides or door without using heat resisting gloves.

Children must be made aware of the dangers and kept away for the stove when lit.

3. TYPES OF FUEL PERMITTED.

Use blocks of wood approx. 30 cm in length and 10 cm in diameter. Certain types of coal can also be used, with the exception of black coal

and anthracite which is not recommended because of overheating causing the cast iron to warp or break.

Wood must be dry. (max. 20% moisture content) Burning synthetic materials, plastic, varnished wood or other materials is strictly

forbidden by law because of emission of harmful gasses endangering health. The chimney and stove will become severely damaged and the

smell produced is a hindrance for the neighbourhood.

Unlike gas or oil, wood cannot burn overnight.

4. OPERATION OF THE STOVE.

Lighting the stove for the first time will cause an unpleasant smell and blue damp. Leaving a window open while the paint is hardening

is recommended. Make sure the fire burns well so that the paint hardening process is successful. Once this is done threre will be no more

trouble with smell and damp. Never use methylated spirits, petrol or other fluids to light the stove, this can be very dangerous.

Using a firelighter is recommended. The wood used must not be younger than 2 years and no older than 6 years. Young wood is too wet and will

produce too much soot. Old wood is not suitable to start a fire as it no longer contains any gasses, which will prevent the right temperature being

reached quickly for a fast and clean burning.

With the technique we use, the fire will burn at its best within 15 to 20 min. Before starting the fire, check to see that all air vents are open.

When the fire is burning well, the fire grid can be closed and the flames regulated with the primary / secondary regulator.

Do not close up completely while flames are visible. (This is to avoid smoke entering the room) Stay with the stove until burning well.

If the fire has been started well the stove should remain quite clean. Wait until the wood has to a glow before putting on more logsburnt

5. GLOBE FIRE RECOMMENDATIONS “ LIGHTING THE FIRE “ ON PAGE 7.

6. AIR SUPPLY.

Always make sure there is enough air in the room.

7. USING THE FIRE IN THE AUTUMN AND SPRING.

In these seasons of the year when the outside temperature is higher your chimney may not have a good chimney draught and the smoke will not be

sucked out enough. In this case it is recommended to use a lot of dry wood (three quarters full) not older than 6 years.

Please in the first heat up, also in de transitional period, the burner as described in the

initial heating recommendation be part!

8. CARE AND MAINTENANCE.

The stove must be cleaned yearly and occasionally even more often. It is recommended that the chimney is swept every year by a professional

chimney sweeper. The Globe-fire stoves have been treated with a heat resisting paint. After this has hardened, the stove can be cleaned with

a damp cloth, using a dry cloth to dry off afterwards.The stove window can be cleaned with a glass cleaner. Badly stained glass can be cleaned

with a special gel or oven cleaner. Never clean the stove when it is hot. Remove the ash between the fire grid so that the grid can revolve easily.

Installation and operation manual for Stove model ST-2800SY

Tested according to German standards: DIN EN 13240, Ö-Standard

15A and 1.+2. BimschV., CE and Luftreinhalte-Verordnung Switzerland

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Globe Fire Eros II Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Globe Fire Eros II

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info