Bedienungsanleitung Gloria Multibrush li-on (Seite 28 von 99) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch)

725139

Zoom out

Zoom in

Vorherige Seite

1/99

Nächste Seite

5 Assembly

Figures 1 - 6

NOTE!

Your device is supplied with the

surface brush pre-assembled. Loose

parts supplied must be as sembled

accordingly when working with the

joint brush.



After removing from the packaging,

loosen screw connection (G) .

Next, turn handle (A) 45° as shown in

fig ure and adjust the length of

the telescopic tube (F) according to

your body height, as illustrated.

5 locking positions are available.

In the selected position, turn handle

(A) a further 45° and tighten the

height of the telescopic tube (F) with

the screw connection (G) by hand.



As the device should always be

guided and operated with two hands,

fit the additional handle (E) as shown

in the figure , adjust the height

and screw the additional handle (E)

tightly into place .

6 Prior to initial commissioning

WARNING

BEFORE USE OBSERVE CHAPTER 2 “FOR

YOUR SAFETY”. You should therefore

observe the following safety instruc-

tions:



The mains voltage must be in com-

pliance with the voltage specifica-

tion (V~) on the type plate of the

charger.

Operate charger only in dry rooms.

NOTE!



Before initial use, fully charge battery

(C). Please ensure that the charging

procedure is performed at room tem-

perature. This is the only way to ensure

a long battery life.



A significantly decreased runtime in

spite of charging indicates that the bat-

tery is dead and must be replaced.

Use only original Li-Ion batteries, which

you can purchase from manufacturer’s

customer service.



Charger and battery can heat up during

charging. This is normal and not a sign

of a technical defect.



The Lithium-Ion battery can be charged

at any time, regardless of charge state.

Premature interruption of charging

does not cause damage to the battery.

A protective circuit on the battery pre-

vents depth discharge of battery.



The battery is equipped with tempera-

ture monitoring that only permits

charging over a temperature range

between 0 °C and 45 °C. This ensures a

long battery life.



Do not press the On/Off switch again if

the device has switched itself off auto-

matically. The battery can be damaged.

Note the details concerning disposal of

the battery.

6.1 Charging procedure

Figures 7a - 7b

These figures refer to the 18.0 V

/ 4.0 Ah battery and the AL

1810 CV charger.

The charging process starts as soon

as the plug has been plugged into

the power outlet and the battery (C)

has been placed in the charger (G).

Due to the intelligent charging method,

the charging condi- tion of the battery is

automatically detected and the battery is

charged with the optimum charging cur-

rent, depending on battery temperature

and voltage. This gives longer life to the

battery and always leaves it fully charged

when kept in the charger for storage.

RZ_MULTIBRUSH_Li-on__DE/GB/FR/NL/IT/DK_979162.qxp_Text_GB 04.03.20 17:01 Seite 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gloria Multibrush li-on Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info