Bedienungsanleitung Godox Speedlite Ving V350C Canon (Seite 14 von 14) (Englisch)

708927

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

If there is a problem, refer to this Troubleshooting Guide.

The Camera Flash cannot be charged.

● The battery is installed in the wrong direction.

→Install the battery in the correct direction.

● The camera flash’s internal battery is exhausted.

→If < > appears and blinks on the LCD panel, recharge the

battery immediately.

The Camera Flash does not fire.

● The camera flash is not attached securely to the camera.

→Attach the camera’s mounting foot securely to the camera.

● The electrical contacts of the Camera Flash and camera are dirty.

→Clean the contacts.

The power turns off by itself.

● After 90 seconds of idle operation, auto power off took effect if the

flash is set as master.

→Press the shutter button halfway or press any flash button to

wake up.

● After 60 minutes of idle operation, the flash unit will enter sleep

mode if it is set as slave.

→Press any flash button to wake up.

Auto zoom does not work.

● The camera flash is not attached securely to the camera.

→Attach the camera flash’s mounting foot to the camera.

The flash exposure is underexposed or overexposed.

● You used high-speed sync.

→With high-speed sync, the effective flash range will be shorter.

Make sure the subject is within the effective flash range

displayed.

● You used Manual Flash mode.

→Set the flash mode to TTL or modify the flash output.

Photos have dark corners or only parts of the target subject

are illuminated.

● The focal length of lens exceeds the flash coverage.

→Check the flash coverage you set. This flash unit has the flash

coverage between 24 and 105mm, which fits full-format

cameras. Pull the wide panel out to extend the flash coverage.

Troubleshooting Compatible Camera Models

This flash unit can be used on the following Canon camera models:

● This table only lists the tested camera models, not all Canon cameras.

For the compatibility of other camera models, a self-test is recommended.

● Rights to modify this table are retained.

● Shut down the device immediately should abnormal operation be detected.

● Avoid sudden impacts and the product should be dedusted regularly.

● It is normal for the flash tube to be warm when in use. Avoid continuous flashes

if unnecessary.

● Maintenance of the flash must be performed by our authorized maintenance

department which can provide original accessories.

● This product, except consumables e.g. flash tube, is supported with a one-year

warranty.

● Unauthorized service will void the warranty.

● If the product had failures or was wetted, do not use it until it is repaired by

professionals.

● Changes made to the specifications or designs may not be reflected in this

manual.

Maintenance

- 51 -

- 52 -

A. This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including interference

that may cause undesired operation.

B. Warning: Changes or modifications to this unit not expressly approved by the

part responsible for compliance could void the user’s authority to operate the

equipment.

C. NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Statement

1Dx Mark II

7D Mark II

60D

650D

100D

5D Mark II

77D

750D/760D

400D Digital

70D

700D

350D DIGITAL

1Dx

50D

600D

1200D

5Ds/5Dsr

6D Mark II

40D

550D

1000D

5DIV

30D

500D

1100D

5D Mark III

80D

800D

450D

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Godox Speedlite Ving V350C Canon Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info