Bedienungsanleitung Gorenje B3350E (Seite 9 von 13) (Englisch)

512703

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

Instructions for use, installation and connection

• Cool the oven completely before cleaning.

• The oven and the accessories must be cleaned after each

use, otherwise stains might get burned in.

• Oven walls, sprayed with oil from roasting, is best cleaned

with warm water and detergent when the oven is still tepid.

• Hard and heavily stained oven should be cleaned with

special oven cleaning agents. Rinse the cleaner thoroughly

and remove any detergent remaining before the next use.

• Never use aggressive cleaners, like polishing agents, dish

cleaning accessories, corrosion inhibitors, or any other

devices that might cause scratches.

• Coated, stainless steel or zinc-coated surfaces or aluminum

parts must not come into contact with oven sprays, since

they might cause damage or discoloration. The same goes

for thermostat probe (if the cooker is equipped with it) and

exposed heaters on the oven ceiling.

• When purchasing cleaning agents remember the

environment, and strictly follow the manufacturer's

instructions.

Removing wire and telescopic guide grids

Telescopic guide grids or wire guides may be removed to

facilitate the cleaning of the oven. Side grids are removed by

swinging the bottom side inwards and unhooking them from

their place.

Clean the side grids and telescopic guides only with

conventional detergents.

Telescopic guides may not be washed in a dishwasher.

Note! Never lubricate the telescopic guides!

To reinsert, repeat the procedure backwards: slide them into

the holes and swing downwards.

Oven ceiling

(differ according to different models)

To facilitate the cleaning of the ceiling some ovens are

equipped with the foldable infrared heater.

• Before lowering the infrared heater disconnect the appliance

from the mains by unlocking the fuse or switching off the

main switch.

• The heater must be cooled down, otherwise you might get

burned!

• Never use the heater in the lowered position!

Before cleaning remove all pans, grids and guides, and using

suitable tools (knife or a screwdriver) loosen the cross bar from

its side supports (see fig.). Use your other hand to hold the

heater and fold it downwards.

After cleaning simply push the heater back and the cross bar

will click into position.

Removing oven door

(differ according to different models)

Open the door to the horizontal position. Pull the bottom hinge

supports upwards to the vertical position and lock them to the

latch of upper hinge support. Close the door halfway (see fig.)

and pull it out.

For reinserting the door repeat the procedure backwards. Insert

the door in half open position (at an angle of 60°) by pushing

them all the way in during opening. Be sure that the notches on

bottom hinge carriers fit exactly the oven floor. Now open the

door completely, remove the hinge clamps from the upper

hinge latches and return them into the horizontal position.

1 door hinge in 2 door hinge during

operating position dismantling

Removing oven door with a single axe hinge

(differ according to different models)

Open the door completely and turn the removable locks

backwards (see fig). Then close the door slowly and let the

locks fit to the notches. At an angle of about 15° lift the door

slightly up and pull the door from the hinge supports (fig. 2).

For reinserting the door repeat the procedure backwards. Insert

the door at an angle of about 15° into the hinge supports by

pushing them forward and downwards, so the hinges lock into

their slots (fig. 3). Check if the hinges are locked into their

respective slots.

Now open the door completely and turn the removable locks

into their original position. Close the door slowly and check if

they close properly (fig. 4). If you have trouble closing the door,

check if the hinges are properly inserted into their slots.

Attention! Never let the hinge locks spring out, as the springs

are strong and may cause injuries.

Accessories

Accessories, like biscuit tray, oven grid, etc. are cleaned with

hot water and the usual detergent.

Special enamel

Oven, interior door lining, baking tray and grease interception

pan are coated with special enamel, with smooth and resistant

surface.

This special coating facilitates cleaning at room temperature.

Grease filter

Clean the grease filter after each use with soft brush in hot

water with some detergent, or wash it in the dishwasher.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje B3350E Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info