2
SAFETY WARNINGS
1. Remove the packaging and make sure the device is undamaged. In case of doubt,
consult the service centre.
Keep the packaging out of the reach of children and persons with disabilities.
2. The device may only be used for applications specified in these instructions.
3. INSTALLATION
The device can be mounted on the ceiling, wall or window. Use the attached
mounting equipment. The fan's exhaust must be vented out of the room or into the
building's ventilation system.
Installation must be carried out by qualified personnel.
4. ELECTRICAL CONNECTION
The fan motor must be connected to a single phase power supply as indicated on the
nameplate. Connectors for the switch are located on the fan housing. To ensure
adequate IP protection, use appropriate fittings for electrical cables. The fan must be
securely mounted and connected with electric cables with minimum cross-section of 1
mm
2
. The fan does not need an earth wire, as it is specified as a device with double
insulation (class 2).
The device must be connected to the power supply by a qualified electrician.
Connect the cable to the fan via a bipolar switch which must have a minimum
spacing of 3 mm in all poles.
The device must be connected in accordance with national standards.
Do not touch the device with moist or wet hands!
Do not touch the device while barefoot! Before cleaning or maintenance, turn off
the mains power supply by means of the bipolar switch or disconnect the plug.
6. In the event of a breakdown or malfunction, switch off the device and do not tamper
with it. If repairs are needed, please contact the service centre. Always insist on
genuine spare parts
7. When the device is not in use, disconnect it from the mains power supply.
8. The maximum permitted temperature of the room where the device is installed is
40°C.
9. The device should not be used unattended by children, disabled persons or
persons with reduced capabilities.
Children should always be supervised to ensure they do not play with the
device.
10. Do not use near flammable materials or their vapours (gasoline, alcohol, insecticides).
11. Prevent the inflow of flue gas in the room in the case of installed devices with an
open combustion chamber
12. Do not modify the device.
13. Do not expose the device to weather conditions (rain, sun, etc.) .
14. Inspect the device regularly. In the event of identified defects, stop using the device.
15. In the event of a fall or strong impact, the device must be checked by qualified
personnel.
16. The room where the fan is installed must have an adequate supply of air to ensure
efficient operation.
17. Do not cover the humidity sensor or motion sensor
