Bedienungsanleitung Gorenje D98F66 (Seite 2 von 2) (Englisch)

604112

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

www.gorenje.com

(1a)

en (03-15)











SP 10 EXCL HP GP A+++_n

EMPTYING THE

CONDENSATE TANK

CLEANING THE STEAM

GENERATOR TANK

FILTER

Remove the condensate

tank and turn it upside down

above the sink or vessel to

empty.

Pull out the spout at the

opening for easier emp-

tying (only some models).

Each time you empty the

condensate tank, clean the

steam generator tank filter.

Remove the filter from the

support bed in the condensate

tank housing.

Clean the filter thoroughly

under running water, if

necessary.

Also clean the filter support bed.

Put the filter and the condensate

tank back into place.

Empty the

condensate tank after

each drying cycle.

Make sure the remains of

the fibres do not enter

the dryer as this may

clog the system.

CLEANING THE

HEAT PUMP FILTER

Place an absorbent cloth on

the floor in front of the dryer.

Open the outer cover, then hold

the handle on the left side and

pull downwards.

Use the handle to remove

the heat pump foam filter

from the dryer.

Remove the filter from

its handle and use a

damp cloth to clean the

housing.

Wash the filter under running

water. Dry the filter and put

it back.

Clean the foam

filter at least

after

every five drying

cycles.

Push the exterior cover

upwards towards the

appliance until it snaps

back into place.

TIPS

FOR ECONOMICAL

USE OF YOUR DRYER

FOR SMOOTH AND

SOFT LAUNDRY

• Dry the recommended amount of laundry in each

batch (see step 3 - Program Table).

• It is not recommended to dry laundry made

of particularly delicate fabrics that may be

deformed.

• Drying time will be shorter and power

consumption will be lower if the garments are

thoroughly wrung or spun before drying.

• Regular cleaning of the filters will lead to

optimum drying time and minimum power

consumption.

• Use of conditioner in the washing cycle is not

necessary when the clothes are dried in a dryer.

TIPS FOR ECONOMICAL USE TIPS FOR SMOOTH AND SOFT LAUNDRY

• Select the appropriate drying program to avoid

over-drying your laundry and problems with

ironing or shrinkage of fabric.

• Remove laundry right after the end of the drying

cycle to prevent it from creasing again.

• Use steam generator to straighten the creases

and refresh the laundry.

• Ionizer system adds negative ions into dryers

drum - the fibre will be flexible and your clothes

will be tender and easy to iron.

• Dry smaller amount of laundry or single items

with the timed program. When drying smaller

amounts of laundry, the sensor may not perceive

the actual level of moisture.

For detailed instructions please read the

extended manual.

QUICK INSTRUCTIONS

HOW TO USE YOUR

DRYER

CLEANING THE NET

FILTER

Clean the filters

after each drying.

Be careful not to

harm yourself during

opening/closing of the

net filter cover.

PROBLEM/

ERROR

CAUSE

WHAT TO DO ...?

Problem/error Cause What to do ...?

Laundry is not

dried, or drying

temperature is

longer than 4h.

• Filters are not clean.

• The room is not sufficiently ventilated.

• Inappropriate temperature in the room

• Laundry was not sufficiently wrung

or spun.

• Amount of laundry dried in the

appliance is too large or insufficient.

• Clean the filters.

• Install the dryer in an appropriate room.

• Check if the temperature in the room where the dryer is

installed is too high (over 25°C) or too low (below 10°C).

• Laundry inserted into the dryer was not sufficiently wrung

or spun, or an inappropriate drying program was selected.

Unevenly dried

laundry.

• The amount of laundry dried at a time

is too large.

• Drying the pieces of different

thicknesses

• Drying the different types of laundry

• Make sure the laundry is sorted by type and size of items

given the selected program.

Error in the drum

lighting.

• There is no lighting when the dryer

door is opened.

• Disconnect the dryer from the power mains and call an

authorized service unit.

On display: F3 • Full condensate tank

• If the condensate tank is empty, there

is a pump failure.

• Empty the condensate tank.

• Disconnect the appliance and call the nearest service unit.

On display: F4 • Clogged filters

• If the filters are clean, there may be a

compressor failure.

• Clean the filters.

• Disconnect the appliance and call the nearest service unit.

On display: "LO" • Steam generator tank is empty • Add distilled water

Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call thenearest authorized service (call center).

MAINTENANCE & CLEANING

Lift the filter cover.

Scrape the filter cover to

remove the layer of lint and

threads.

Close the filter cover.

510701en.indd 2510701en.indd 2 17.6.2015 8:33:1217.6.2015 8:33:12

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje D98F66 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gorenje D98F66

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info