Bedienungsanleitung Gorenje DK2000P2 (Seite 7 von 60) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

479808

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

8 INSTRUCTION ON MOUNTING AND USE

Description of the hood - Fig. 1

1 Control panel

2 Grease filter

3 Grease filter release handle

4 Halogen lamp

5 Steam screen

6 Air outlet (Filter Version only)

7 Telescopic flue

Operation

To select the functions of the hood just touch the commands.

Light key ON/OFF

Intensive speed selection key (suction power) -

duration 5 minutes - press again to return to previous

setting.

High-speed selection key (suction power).

Medium-speed selection key (suction power) -

when flashing it indicates the need to wash or replace

the carbon filter. This signal is normally deactivated.

Press keys 1 and 2 at the same time to activate it. At

first only key 1 will flash and then both keys 1 and 2

to indicate activation. Repeat the operation to deactivate

the signal. At first keys 1 and 2 will flash and then only

key 1 to indicate deactivation.

Low-speed selection key (suction power) – when

flashing it indicates the need to wash the fats filter.

Motor key OFF (stand by) – excludes the electronics

– reset wash/replace filters signals.

MOTOR OFF

Press briefly to switch the motor off.

RESET FILTERS SIGNALS

After having carried out maintenance of the filters,

press the key for 3 seconds. Flashing led 1 (fats filter)

or 2 (carbon filter) will stop flashing.

EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood command

electronics will be excluded.

This function can be useful during the product cleaning

operations.

Just repeat the operation to reinsert the electronics.

Use the high suction speed in cases of concentrated kitchen

vapours. It is recommended that the cooker hood suction

is switched on for 5 minutes prior to cooking and to leave

in operation during cooking and for another 15 minutes

approximately after terminating cooking.

The steam screen must always be left closed and opened

only for maintenance (e.g. cleaning or changing filters).

If the hood fails to operate correctly, briefly disconnect it

from the mains power supply for almost 5 sec. by pulling

out the plug. Then plug it in again and try once more before

contacting the Technical Assistance Service.

Maintenance

Prior to any maintenance operation ensure that the cooker

hood is disconnected from the power supply.

Cleaning

The cooker hood should be cleaned regularly internally

and externally.

For cleaning use a cloth moistened with denatured alcohol

or neutral liquid detergents. Avoid abrasive detergents.

Warning:

Failure to carry out the basic standards of the cleaning of

the cooker hood and replacement of the filters may cause

fire risks.

Therefore we recommend observing these instructions.

Steam screen

The steam screen must always be left closed and opened

ONLY for maintenance (e.g. cleaning or changing filters).

Opening the steam screen:

Press the lower part of the steam screen firmly. After

coupling, accompany it upward.

Closing the steam screen:

Accompany the steam screen downwards, press firmly

and check the resulting coupling.

Grease filter

This must be cleaned once a month using non aggressive

detergents, either by hand or in the dish-washer, which

must be set to a low temperature and a short cycle.

When washed in a dish-washer, the grease filter may

discolour slightly, but this does not affect its filtering

capacity.

Removing the grease filters - Fig. 2

Open the steam screen.

Pull the handle downwards and extract the filter.

Charcoal filter (filter version only)

It absorbs unpleasant odours caused by cooking.

The charcoal filter can be washed once every two months

using hot water and a suitable detergent, or in a dish-

washer at 65°C (if the dish-washer is used, select the full

cycle function and leave dishes out).

Eliminate excess water without damaging the filter, and

put it in the oven for 10 minutes at 100° C to dry completely.

Replace the mattress every 3 years and when the cloth

is damaged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje DK2000P2 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info