Bedienungsanleitung Gorenje ect 890 e (Seite 14 von 17) (Englisch)

334142

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

136356

• Connections may be carried out by a qualiﬁ ed technician only. The earthing protection must

comply with the standing regulations.

• Connection terminals are revealed when the connection box cover is removed.

• Prior any attempted connection check that the voltage indicated on the rating plate is in line with

your home power supply.

• The rating plate is located underneath the appliance.

• The appliance is manufactured for use with the power supply voltage AC 230 V.

• The electric wiring should be equipped with a circuit breaker able to isolate the appliance from

the mains in all points, with the distance between terminals of at least 3 mm in open position.

This may be done by means of fuses, safety switches, etc.

• The connection should be selected in accordance with the declared charge capacity of the mains

and the fuse power.

• Such appliances are allowed to be mounted on one side next to a high kitchen cabinet, the

height of which may exceed that of the appliance. On the opposite side however, only a kitchen

cabinet of equal height as the appliance is allowed.

• Upon the completion of installation, live wires and isolated cables must be adequately protected

against accidental touching.

• Distance between the cooktop surface and the cooking hood must be such as indicated in the

instructions for use of the hood.

• Kitchen cabinets may not be mounted underneath the built-in ceramic-glass cooktop.

Upon each connection to the power supply the sensors of the

appliance are automatically adjusted to the environment to

ensure their proper function.

During the adjustment procedure the sensors must be free of any

objects, otherwise the adjustment procedure will be interrupted

until such objects are removed from the sensor surface. During

this period the regulation of the cooktop is impossible.

Note: After the ﬁ rst connection of the appliance to the mains you

may notice the symbol “H” ﬂ ashing on the indicators for certain

period of time following the synchronization of the appliance.

This is the consequence of preceding factory testing whereby

hotplates may have remained hot (See: Remaining Heat

Indication).

ATTENTION !

Before attempting any repairs on the appliance, disconnect

the power supply. In accordance with the mains voltage the

appliance should be connected in line with the attached diagram.

The earthing wire (PE) must be connected to the terminal

marked with the earthing symbol

The connection cable must lead through the relief safety device,

protecting it from accidental pulling out.

Upon the completion of installation switch all the hotplates on for

about 3 minutes to check the proper functioning.

Connection to power supply

Basic adjustment of

sensors to the ambience

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje ect 890 e Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info