Bedienungsanleitung Gorenje F6152AW (Seite 23 von 24) (Englisch)

589023

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

302967

Problem: Cause or remedy:

After connecting to the power

mains, the appliance does not

operate:

• Make sure the wall outlet is powered and that the appliance

is plugged in.

Cooling system has been

working continuously for a long

period of time:

• Too high environment temperature.

• Door is open too often or it is left open too long.

• Door is not closed appropriately (there may be dirt between

the door and the refrigerator, the door may be tilted, the seal

should be checked, etc.).

• Too much fresh food was inserted.

• Insufﬁ cient compressor and condenser cooling. Check the air

circulation behind the appliance and clean the condenser.

Ice accumulation in the freezer

interior is a result of:

• Poor door sealing. If the seal is dirty or damaged, clean or

replace it.

• Door is opened too often or left open too long.

• Placing warm food into the freezer.

D light is on/is ﬂ ashing: • Frequent opening of the door, door open too long.

• Door not closed properly (particle between door gasket,

sagged door, damaged gasket, etc...).

• Excessively long power failure.

• Excessive quantity of fresh food inserted at once.

Door won’t open easily: • If you wish to open freezer door immediately or shortly after

closing it, you may feel rather strong resistance. When the

freezer door is opened, some cool air escapes from the

freezer compartment and it is replaced by warm air from the

environment. When this air is cooled, a sub-pressure builds

up, causing resistance to door opening. After a few minutes,

the condition is normalized and the door can be easily

opened again.

Bulb replacement (certain

models only):

• Before replacing the light bulb, disconnect the appliance form

the power supply. Remove the plastic cover, replace the bulb

with a new one (E 14, max. same voltage as the factory one)

and ﬁ t back the cover.

• Please dispose of this correctly.

• Light bulb is consumption material and is not covered by the

warranty.

• Bulb lamps used in this appliance are special purpose lamps

selected for household appliances use only. They are not

suitable for household room illumination.

Signal light B is ﬂ ashing: • If the signal light B is ﬂ ashing, call a service technician.

Occurrence of murmur after

closing the door:

• After closing the door, some murmur can occur. This

phenomenon is normal and is due to pressure equalisation

Error code displayed (certain

models only):

•

If the character E appears on the digital display (certain

models only), call service assistance.

If none of the above reasons seems to match your problem, please contact the nearest service

center and state the type, model and serial number as indicated on the label with basic information

attached in the appliance interior.

Troubleshooting

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje F6152AW Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gorenje F6152AW

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info