603275
13
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
266871
The appliance may only be connected by an authorized skilled technician.
Electric system protection should comply with all relevant regulations.
The connection clips can be accessed when the connection clip covers are opened / removed.
Before connecting the appliance, make sure the voltage indicated on the rating plate is consistent
with the voltage in your home circuit.
The rating plate with basic information is attached on the lower side of the hob.
The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
The connection should be selected according to the installation possibilities with regard to current
and fuses.
Given the protection from the risk of re, appliances of this type may be installed in a worktop next
to a piece of kitchen furniture that is taller than the appliance (when installed); however, in this
case, a kitchen furniture element must be installed on the other side, adjacent to the appliance.
The current conducting and isolated parts must be protected from any possibility of direct contact.
WARNING!
Before any intervention, disconnect the appliance from the power mains. Connect the appliance in
compliance with the electric connections diagram supplied; make sure the relevant network voltage is
Important warnings
The worktop should be installed completely horizontally.
The cutoff surfaces should be appropriately protected.
Attach the fastening elements (4) with the supplied screws (4)
to the front and rear wall of the cooking hob and the worktop
cutoff.
Connect the cooking hob to the power mains and gas supply
(see instructions for connecting a cooking hob on a power
network and gas supply).
Attach the supplied adhesive seal on the lower edge of the
cooking hob.
Insert the cooking hob into he cutoff and press it heavily from
above towards the worktop.
For screwing down the xing clip it is not allowed to use
screws longer than 6,5 mm.
Installation procedure
13
Connecting the appliance to the power mains
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gorenje GHS64ORAS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gorenje GHS64ORAS

Gorenje GHS64ORAS Bedienungsanleitung und Installationsanweisung - Deutsch - 13 seiten

Gorenje GHS64ORAS Bedienungsanleitung und Installationsanweisung - Holländisch - 20 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info