Bedienungsanleitung Gorenje gin 4703 w (Seite 10 von 15) (Englisch)

326513

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Instructions for use and installation

• Never use aggressive cleaners, like polishing agents, dish

cleaning accessories, corrosion inhibitors, or any other

devices that might cause scratches.

• Coated, stainless steel or zinc-coated surfaces or aluminum

parts must not come into contact with oven sprays, since

they might cause damage or discoloration. Oven bottom

should be removed, thoroughly cleaned and reinserted after

cleaning.

• Never clean the oven burner yourself. This should be done

by the authorized person only. Cleaning will be required

when the flame no longer escapes from all burner nozzles.

• When purchasing cleaning agents remember the

environment, and strictly follow the manufacturer's

instructions.

Removing wire guides

Wire guides may be removed to facilitate the cleaning of the

oven. Side grids are removed by swinging the bottom side

inwards and unhooking them from their place. Clean them only

with conventional detergents.

To reinsert, repeat the procedure backwards: slide them into

the holes and swing downwards.

Oven drawer

(certain models only)

The oven drawer is protected from accidental opening.

It may be open by lifting upwards. To remove the drawer from

the cooker pull it out to the limit, then lift upwards and pull out

completely.

Never place any flammable, explosive, or temperature non-

resistant substances or objects in the drawer.

Certain types of cookers require the rear bottom drawer slide to

be inserted into the drawer guide and pushed inside.

The drawer may also be equipped with wheel side slides. To

insert this type of drawer, slide the wheels into the slide guides

and push inwards.

Removing oven door

(certain models only)

Open the door to the horizontal position. Pull the bottom hinge

supports upwards to the vertical position and lock them to the

latch of upper hinge support. Close the door halfway (see fig.)

and pull it out.

For reinserting the door repeat the procedure backwards. Insert

the door in half open position (at an angle of 60°) by pushing

them all the way in during opening. Be sure that the notches on

bottom hinge carriers fit exactly the oven bottom. Now open the

door completely, remove the hinge clamps from the upper

hinge latches and return them into the horizontal position.

1 door hinge in

operating position

2 door hinge during

dismantling

Removing oven door with a single axe hinge

(certain models only)

Open the door completely and turn the removable hinge locks

backwards (see fig). Then close the door slowly and let the

locks fit to the notches. At an angle of about 15° lift the door

slightly up and pull the door from the hinge supports (fig. 2).

For reinserting the door repeat the procedure backwards. Insert

the door at an angle of about 15° into the hinge supports by

pushing them forward and downwards, so the hinges lock into

their slots (fig. 3). Check if the hinges are locked into their

respective slots.

Now open the door completely and turn the removable locks

into their original position. Close the door slowly and check if

they close properly (fig. 4). If you have trouble closing the door,

check if the hinges are properly inserted into their slots.

Attention! Never let the hinge locks spring out, as the springs

are strong and may cause injuries.

Accessories

Accessories, like baking tray, oven grid, etc. are cleaned with

hot water and the usual detergent.

Avoid cleaning the aluminum baking pan with aggressive

cleaners causing scratches. The pan surface will lose its shine

with time. This is unavoidable, and does not affect your baking

results.

Special enamel

Oven interior and door lining are coated with special enamel,

with smooth and resistant surface.

This special coating facilitates cleaning at room temperature.

Troubleshooting guide

• Any unskilled attempt to repair the appliance is extremely

dangerous as it might cause electric shock and short circuit.

To avoid such injuries any repairs may be performed only by

qualified personnel, or after sales service.

• Before attempting any repairs disconnect the appliance from

the mains by removing the fuse or unplugging the mains

lead from the mains socket.

Note!

There are, however, some minor faults which may be easily

removed by the user, in accordance with the instructions that

follow.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje gin 4703 w Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info