Dishwasher must be level for proper dish rack operation and wash performance.
Place a spirit level on door and rack track inside the tub as shown to check that the
dishwasher is level.
level the dishwasher by adjusting the three levelling legs individually.
When level the dishwasher, please pay attention not to let the dishwasher tip over.
1
2
3
Illustration of feet adjustment
Ǐ ǐFigure 8
NOTE:
The maximum adjustment
height of the feet is 50 mm.
This appliance must be earthed. In the event
of a malfunction or breakdown, earthing will
reduce the risk of electric shock by providing a
path of least resistance for the electric current.
This appliance is equipped with a cord having an
equipment-earthing conductor and an earthing
plug. The plug must be plugged into an appropriate
outlet that is installed and earthed in accordance
with all local standards and requirements.
Improper connection of the equipment-
earthing conductor can resul t in th e risk
of an electric shock. Che ck with a qualified
electrici an or service represe ntativ e if you
are in doubt whether the appliance is properly
earthed. Do not modify the plug p rovided with
the appliance; If it is not fit for the outlet.
Have a proper ou tlet installed by a qualifi ed
electrici an.
Ensure the voltage and frequency of the power being corresponds to
those on the rating plate. Only insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appliance must be conne cted is not
appropriate for the plug , replace the socket, rather th an using a adaptors or t he like as
they could cause overhea ting and burns.
Plea se look at the ra ting label to know the rating voltage and connect the dishwasher to the appropriate power supp ly.
Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and provide separate circuit serving
only this appliance.
For personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE EARTHING
CONNECTION FROM THE POWER CORD.
20
Check l evel si de to side
Spirit level
Chec k leve l Front to B ack
1.Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
2.Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
3.Turn water fully on before starting the dishwasher.
The appliance must be connected to the water mains using new hose-sets. The old hose-sets
should not be reused.
Water pressu re must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
