Bedienungsanleitung Gorenje k 256 otla 4 (Seite 7 von 7) (Englisch)

353980

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

Instructions for Use

• Do not forget to clean also the defrost water receptacle

above the refrigerator compressor (do not remove the

receptacle).

After cleaning, connect the appliance to power supply and

reload the packages.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for a longer period, set

the thermostat knob to the STOP (0) position, disconnect the

power supply, take out the foods and defrost and clean the

appliance. Leave the door slightly open.

Trouble-Shooting Guide

During the service, you can come across some troubles that in

most cases result from improper handling of the appliance and

can easy be eliminated.

The Appliance Fails to Operate After connecting to the

Mains Supply

• Check the supply in the outlet socket and make sure the

appliance is switched on (thermostat in operating position).

Continuous Operation of the Refrigerating System

• The door was frequently opened or it was left opened for too

long.

• The door is not properly closed (the door may sag, the

gasket may be polluted or damaged).

• Perhaps you have overloaded the appliance with fresh

foods.

• The reason may be inadequate ventilation of the compressor

and condenser (assure adequate air circulation and wipe off

the condenser).

• Continuous operation button activated (see section Freezing

of Food).

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the channel and through

the opening to the drain pan on the compressor, automatic

defrosting of the appliance is assured.

In case the ice formation on the inner back wall is increased (3-

5 mm), ice should be manually defrosted.

Set the thermostat knob to STOP (0) position and leave the

door open. Never use electric devices for defrosting and do not

scrape the ice or frost layer with sharp objects.

After completed defrosting, turn the knob to desired position

and close the refrigerator door.

The cause of increased ice formation may be one of the

following:

− the door does not seal well (clean the gasket if it is

contaminated, or replace it if it is damaged);

− the door was frequently opened or it was left opened for

too long;

− the food stored in the refrigerator was warm;

− the food or dish is touching the inner back wall.

Water is Leaking From the Refrigerator

In case the discharge water outlet is clogged, or the defrost

water drips over the channel, water leaks from the refrigerator.

• Clean the clogged opening, for example with a plastic straw.

• Manually defrost the increased ice layer. See "Ice Formation

on the Inner Back Wall".

The Freezer Door is Hard to Open

If you want to open the door that has just or recently been

closed, you may find it hard to open. The reason why this

happens is, that when you open the door, warm air gets into

the appliance and when it is getting cool, the underpressure

seals the door. After few minutes (5-10), the door can easily be

opened.

Noise

Cooling in refrigerating-freezing appliances is enabled by the

refrigerating system with compressor, which produces noise.

How noisy the appliance is depends on where it is placed, how

it is used and how old the appliance is.

• During the operation of the compressor the noise of liquid

is heard and when the compressor is not operating, the

refrigerant flow is heard. This is a normal condition and it

has no influence whatsoever on the lifetime of the appliance.

• After starting the appliance, the operation of the

compressor and the refrigerant flow may be louder, which

does not mean that something is wrong with the appliance

and it has no influence on the lifetime of the appliance.

Gradually the noise is reduced.

• Sometimes unusual and stronger noise is heard, which is

rather unusual for the appliance. This noise is often a

consequence of inadequate placing.

− The appliance shall be placed and levelled firmly on

solid base.

− It should not touch the wall or kitchen units standing next

to it.

− Check the accesories in the interior of the appliance,

they should be placed correctly in their positions; also

check the bottles, tins and other vessels that might

touch each other and rattle.

Bulb Replacement

Before replacing the light bulb, disconnect the appliance form

the power supply.

Press the cover at the rear side (in the arrow 1 direction) and

remove the plastic cover (in the arrow 2 direction). Replace the

bulb with a new one (E14, max. 15 W).

Don't forget: the old bulb does not belong to organic waste.

Light bulb is consuming good therefore our in-guarantee

service does not relate to it.

RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE ON THE OPERATION

OF THE APPLIANCE.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje k 256 otla 4 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info