Bedienungsanleitung Gorenje R2746 OPLA (Seite 6 von 7) (Englisch)

512730

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

141903

Instructions for Use

in the inner back wall into the drain pan situated above the

compressor, from where it evaporates.

Manual Defrosting of the Low Temperature

Compartment

When the frost and ice layer in the low temperature

compartment is 3-5 mm thick, you should clean the freezer.

• Turn the thermostat knob to STOP (0) position and

disconnect the power supply. Empty the compartment and

take care that the packages remain frozen.

• Use a suitable cloth to dry the defrost water collected during

defrosting on the bottom of the low temperature

compartment. Leave the door of the compartment open to

accelerate defrosting.

• Avoid using defrosting sprays, as they may cause damage

to the plastic parts and may be hazardous to health.

Cleaning the Appliance

Disconnect the power supply before cleaning the

appliance.

Do not use coarse or aggressive cleaning agents as you can

damage the surface.

Be careful to remove any cleanser agent remaining after

cleaning.

• Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft cloth and an

alcohol based cleaning agent (for example glass cleaners).

You may also use alcohol (ethanol or isoprophylic alcohol).

The application of abrasive and specially aggressive

cleaners, such as the stainless steel cleaners, is not

appropriate for the cleaning of plastic and coated parts.

• Remove the detachable accesories in the interior of the

appliance and clean it with water and liquid detergent.

Plastic parts cannot be washed in washing machine.

• Wash the interior of the appliance with lukewarm water, in

which you added one or two spoonfuls of vinegar.

• Every now and then wipe the condenser on the rear wall.

Use soft non-metal brush or vacuum cleaner.

• Do not forget to clean also the defrost water receptacle

above the refrigerator compressor (do not remove the

receptacle).

After cleaning, connect the appliance to power supply and

reload the packages.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for a longer period, set

the thermostat knob to the STOP (0) position, disconnect the

power supply, take out the foods and defrost and clean the

appliance. Leave the door slightly open.

Trouble-Shooting Guide

During the service, you can come across some troubles that in

most cases result from improper handling of the appliance and

can easy be eliminated.

The Appliance Fails to Operate After connecting to the

Mains Supply

• Check the supply in the outlet socket and make sure the

appliance is switched on (thermostat in operating position).

Continuous Operation of the Refrigerating System

• The door was frequently opened or it was left opened for too

long.

• The door is not properly closed (the door may sag, the

gasket may be polluted or damaged).

• Perhaps you have overloaded the appliance with fresh

foods.

• The reason may be inadequate ventilation of the compressor

and condenser (assure adequate air circulation and wipe off

the condenser).

• Continuous operation button activated (see section Freezing

of Food).

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the channel and through

the opening to the drain pan on the compressor, automatic

defrosting of the appliance is assured.

In case the ice formation on the inner back wall is increased (3-

5 mm), ice should be manually defrosted.

Set the thermostat knob to STOP (0) position and leave the

door open. Never use electric devices for defrosting and do not

scrape the ice or frost layer with sharp objects.

After completed defrosting, turn the knob to desired position

and close the refrigerator door.

The cause of increased ice formation may be one of the

following:

− the door does not seal well (clean the gasket if it is

contaminated, or replace it if it is damaged);

− the door was frequently opened or it was left opened for too

long;

− the food stored in the refrigerator was warm;

− the food or dish is touching the inner back wall.

Water is Leaking From the Refrigerator

In case the discharge water outlet is clogged, or the defrost

water drips over the channel, water leaks from the refrigerator.

• Clean the clogged opening, for example with a plastic straw.

• Manually defrost the increased ice layer. See "Ice Formation

on the Inner Back Wall".

Noise

Cooling in refrigerating-freezing appliances is enabled by the

refrigerating system with compressor, which produces noise.

How noisy the appliance is depends on where it is placed, how

it is used and how old the appliance is.

• During the operation of the compressor the noise of liquid

is heard and when the compressor is not operating, the

refrigerant flow is heard. This is a normal condition and it

has no influence whatsoever on the lifetime of the appliance.

• After starting the appliance, the operation of the

compressor and the refrigerant flow may be louder, which

does not mean that something is wrong with the appliance

and it has no influence on the lifetime of the appliance.

Gradually the noise is reduced.

• Sometimes unusual and stronger noise is heard, which is

rather unusual for the appliance. This noise is often a

consequence of inadequate placing.

− The appliance shall be placed and levelled firmly on solid

base.

− It should not touch the wall or kitchen units standing next

to it.

Gorenje R2746 OPLA Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info